Eaton Eaton 5PX Manual 

Eaton®setUPS_5PX_firmware_upgrade_rev_02 Page 10/14 And on setUPS window, the firmware upgrade steps appear : 9. Upload success  When the firmware flash process is done, the UPS fans start and the UPS emits a long beep. The display on the UPS returns back to the normal OFF state. The setUPS issues a pop up to let know the firmware flash has been successful : Click on “OK” : ...

Eaton®setUPS_5PX_firmware_upgrade_rev_02 Page 12/14 Once the UPS is ON, the following screen appears : Loads can now be powered back ON ! ...

Eaton®setUPS_5PX_firmware_upgrade_rev_02 Page 11/14 10. Return to normal state  The setUPS reverts back to the UPS information section. The firmware version should now reflect the latest version : 11. UPS ON  Press and hold the power button for 3 seconds to turn the UPS back ON : ...

Eaton®setUPS_5PX_firmware_upgrade_rev_02 Page 9/14 7. Confirmation  The following screen appears which reminds you that UPS output is OFF during the upgrade, select “Yes” to continue 8. Upgrade process  A click noise comes from the UPS (relay) and it transfers into Boot loader mode. The firmware will then be erased and then rewritten into the UPS. During the flash process, the display on the UPS goes blank and the AC line, the battery and the Alarm lights cycle. This is normal. ...