Arjohuntleigh Flowtron ACS800 User Manual Manual

Front Case There are two sets of LED indicators on the front case of the pump. Their status is as follows: LED Colours Pump Status Warnings/Alarms Extinguished Off or Standby - - Green (Static) Run • No fault detected. • Warning only detected. Red (Flashing) Run Fault detected with full audible and visual alarm ...

the garments on a different patient after treatment. Connect the garment(s) to the pump by pushing the garment connector firmly into the pump tubeset connector until it “clicks”. The pump LCD screen will show which garments are connected to each tubeset connector: the garment connector with the blue push button is “1” and the one with the orange push button is “2”. If any pump options (Audio Alarm Volume, Patient Hours Meter or Language) need to be changed, they must be changed before the patient therapy is started. Refer t ...

Front Case There are two sets of LED indicators on the front case of the pump. Their status is as follows: LED Colours Pump Status Warnings/Alarms Extinguished Off or Standby - - Green (Static) Run • No fault detected. • Warning only detected. Red (Flashing) Run Fault detected with full audible and visual alarm ...

LCD screen. The LED indications remain unchanged and there is no audible alarm. 2. If the fault is not cleared then the warning is replaced by an audible and visual alarm, which consists of: • A fault message on the LCD screen. • The LED indicators on the front of the pump change to red and start flashing. • An audible alarm will sound which increases in pitch and intensity if the alarm is ignored. The warning and alarm can be cleared by either: • Checking and rectifying the fault on the system, or • Pressing the button below � ...

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 About this Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Intended Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 About Flowtron ACS 800 . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

button to toggle the option on or off. • The text “Hours Run 00001” indicates the current value of the Patient Hours Meter. • To clear the elapsed time showing in the Patient Hours Meter (for example, when therapy is started on a new patient), use the “up” and “down” buttons to select the “Clear Patient Hours” option. • Press the “tick” button TWICE to clear the “Hours Run” to “00000”. The Patient Hours Meter on the LCD screen will show “0h” during therapy, if selected. You must press the “tick” b ...