CHICAGO 93353 Assembly And Operating Instructions Manual

suffix “W-A” (“W” in Canada) to indicate it is acceptable for outdoor use. 7. Make sure your extension cord is properly wired and in good electrical condition. Always replace a damaged extension cord or have it repaired by a qualified electrician before using it. 8. Protect your extension cords from sharp objects, excessive heat, and damp or wet areas. RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS* (120 VOLT) NAMEPLATE AMPERES (At Full Load) EXTENSION CORD LENGTH 25 Feet 50 Feet 75 Feet 100 Feet 150 F ...

1. CAUTION! Never use the Crevice Attachment (27), Funnel Attachment (29), Pinpoint Attachments (30, 31), small Brush Attachment (32), or Straight Insert (34) when using the Vacuum as a blower. (See Figure I.) 2. IMPORTANT: Before using the Vacuum as a blower, make sure to release the Clamps (7) and remove the Front End Cap (1), Cloth Bag (5), and Fiberglass Filter (9). Then, replace the Front End Cap. Failure to do so may overheat and damage the Motor. (See Figure I.) FUNNEL ATTACHMENT (29) CREVICE ATTACHMENT (27) PINPOINT ATTACHMENTS (30, 31) STRAIGHT INSERT ...

Cloth Bag (5), and Fiberglass Filter (9). Thoroughly clean all dirt and debris from the Cloth Bag and Fiberglass Filter. Then, replace the Fiberglass Filter, Cloth Bag, and Front End Cap. (See Figure I.) 4. At least three times a year, replace the Fiberglass Filter (9). 5. To clean the exterior parts of the Vacuum and its accessories, use only a clean cloth and mild detergent. Do not immerse any electrical part of the Vacuum in any liquids. 6. CAUTION! All maintenance, service, or repairs not mentioned in t ...

To Install The Accessory Rack: 1. Attach the two Hose Holders (40) to the Accessory Rack (38), using the two Screws (39). (See Figure G.) 2. Position the Accessory Rack (38) against the wall next to the Vacuum Bracket (37) and Vacuum. Use the two mounting holes in the Accessory Rack as a template to mark the points where two 3/16” holes will be drilled into the wall. Then, temporarily set the Accessory Rack aside. (See Figure G.) 3. Before drilling the two holes in the wall, make sure tha ...

can use either a two or three wire extension cord. 2. As the distance from the supply outlet increases, you must use a heavier gauge extension cord. Using extension cords with inadequately sized wire causes a serious drop in voltage, resulting in loss of power and possible tool damage. (See Figure D, next page.) 3. The smaller the gauge number of the wire, the greater the capacity of the cord. For example, a 14 gauge cord can carry a higher current than a 16 gauge cord. (See Figure D.) 4. When using ...

suffix “W-A” (“W” in Canada) to indicate it is acceptable for outdoor use. 7. Make sure your extension cord is properly wired and in good electrical condition. Always replace a damaged extension cord or have it repaired by a qualified electrician before using it. 8. Protect your extension cords from sharp objects, excessive heat, and damp or wet areas. RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS* (120 VOLT) NAMEPLATE AMPERES (At Full Load) EXTENSION CORD LENGTH 25 Feet 50 Feet 75 Feet 100 Feet 150 F ...