bintec elmeg W2022ac Manual 

setting is preserved after resetting the device. 1.2 Cleaning You can clean your device easily. Use a damp cloth or antistatic cloth. Do not use solvents. Never use a dry cloth; the electrostatic charge could cause electronic faults. Make sure that no moisture can enter the device and cause damage. 1.3 Pin Assignments 1.3.1 Ethernet interface The devices bintec W2022ac and bintec W2022ac-ext have two 10/100/1000 Ethernet in- terfaces. The connection is made via an RJ45 socket. The pin assignment for the ...

Off All LEDs are deactivated. 1.1.4 Scope of supply Your device comes with the following accessories: Cable sets/mains unit/other Documentation bintec W2022ac bintec W2022ac Installation poster Safety notices bintec W2022ac-ext bintec W2022ac-ext 4 external standard WLAN antennas Installation poster Safety notices 1.1.5 General Product Features The general product features cover performance features and the technical prerequisites for installation and operation of your device. The features are summarised in the following table: General Produ ...

device. 4.2.1 Interfaces The existing IP interfaces are listed in the LAN->IP Configuration->Interfaces menu. You can edit the IP configuration of the interfaces or create virtual interfaces for special applica- tions. Here is a list of all of the interfaces (logical Ethernet interfaces and others created in the subsystems). Use the to edit the settings of an existing interface (bridge groups, Ethernet interfaces in routing mode). You can use the New button to create virtual interfac ...

number 5500002091) is available as an accessory. Connect the device to a mains socket. Use the power cord and insert it in the appro- priate socket on your device. Now plug the power cord into a power socket (100–240 V). The status LED signal that your device is correctly connected to the power supply. Optionally, power can be supplied through a standard PoE injector (part number 5530000338). Installation The access points are to be mounted either on the wall or on the ceiling, or use as a table- top dev ...

• &  '( (default value): AES or TKIP is used. WPA2 Cipher For Security Mode =  and  & and for WPA Mode =   and     Select the type of encryption with which to apply WPA 2. Possible values: • & (default value) : AES is used. • &  '(: AES or TKIP is used. Preshared Key Only for Security Mode =  Enter the WPA password. Enter an ASCII string with 8 - 63 characters. Note Change the default Preshared Key! If the key has not been changed, your device will not be protected against unau- thorised acc ...

stored in the working memory (RAM). The contents of the RAM are lost if the device is switched off. So if you modify your configuration and want to keep these changes for the next time you start your device, you must save the modified configuration in the flash memory before switching off using the Save configuration button over the navigation area of the GUI. This configuration is then saved in flash in a file named #+*##. When you start your device, the #+*## configuration file is used by defaul ...

pear if the maximum number of clients is reached. Possible values are whole numbers between  and 8. The default value is 0. Client Band select Select whether the 5 GHz band is preferred. Possible values: • )*  #> #  #+: the 5 GHz band is not preferred, fast roaming is used. •  =.> *  : the 5 GHz band is preferred to be used if available. Note For the  =.> *  setting, configure the same SSID in both client bands. Fields in the menu MAC-Filter Field Description ...