CHC i80 Quicktour

1 1.Prerequisites Hardware: CHC i80 rover , Controller Kit, SIM card ,Lithium Battery, Pole Software: FieldGenius8 2.Steps to set i80 working as rover in internal GSM mode with FieldGenius 2.1 Rover installation Insert the SIM card to i80, screw the rover receiver on the pole, and put the Controller adapter in the right place like the figure. Note: The recommend firmware version of i80 is 1.3.36 or higher. If not, please contact local dealer or CHC Support for latest firmware. 2.2 Rover setting in FieldGenius 1. Power on the receiver Long press the i80 power button until the green and blue LED lights are on. 2. Click on [start] and then FieldGenius. 3. Click [New Project] to create a project or Click [Open] to open one exist project.

2 4. A project file should be selected then click [Continue] for next step 5. Click on [Select Instrument] 6. Select [GNSS Rover] option then click [Edit] to select device and linking method 7. Click [Antenna Height] tab to set the antenna height of the receiver

3 9. Click [Model and Communication] tab→select Make as [CHC], Model as [i80], Port as [Bluetooth] →click [Bluetooth Device List] to add bluetooth device 10. Click [Search] to search the around Bluetooth device.

4 11. Click on the device that matches your device serial number, then click it 12. Type in the PIN Code of the bluetooth then click [OK] button to finish the device edit. 13. Then our target device can be selected in the bluetooth device list. Click [OK] button back to [Model and Communication] interface. 14. The target device can be selected in the drop-down box then click [Connect] button. The software will build the connection to your device

5 14. Select the Link Device as [GSM Module] from the drop-down box, select the Data Format as [Auto Detect] then click the [Setup] button. 15. Please type in the APN info in the Network Options according to the SIM card,then select the Source Type as NTRIP. Click [Press to modify] button to create a NTRIP account information. 16. Please click the [Add] button Type in your CORS information in the blank. Then click the [Ok] button

6 After that the new CORS can be selected in the list, please select the CORS you want to use then click [Select] Then click [Ok] button to finish setting 17. Click [Connect] to finish starting rover 18. Then the green LED will flash and the states will become [Autonomous] to [float] then to [fix],which means the rover is getting the correction data from base. 19. The survey work can be done with the i80