ShinewayTech GET-100 Operation & User’s Manual

Shineway Technologies, Inc. - 1 - 1 Notices Copyright© 2015, ShinewayTech, All rights reserved. No part of this manual may be reproduced in any form or by any means (including electronic storage and retrieval or translation into a foreign language) without prior agreement and written consent from ShinewayTech as governed by international copyright laws. 2 Warranty The material contained in this document is subject to change without notice. ShinewayTech makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. ShinewayTech shall not be liable for errors contained herein or for incidental or consequential damages in connection with furnishing, performance, or use of this material. The battery is a consumable part and is not subject to the instrument warranty. ISO9001 Certification Produced to ISO9001 International Quality System Standard as part of ShinewayTech, objective of continually increasing customer satisfaction through improved process control.

Shineway Technologies, Inc. - 2 - 3 Safety Instructions During each stage of operation of this instrument, please always observe the following safety instructions. Not taking any safety precautions or following the instructions will violate the safety standards of design, manufacturing and application of these instruments. In no case will Shineway Technologies bear the responsibilities for consequences incurred by violation of the following instructions. GENERAL This product is a Safety Class 3 instrument. The protective features of this product may be impaired if it is used in a manner not specified in the operation manual. Environmental conditions This instrument (excluding AC / DC adapter) is Class Ⅱ safety equipment, suitable for use in outdoor environments pollution degree 2 and at the maximum relative humidity 93% (non-condensing). For the AC voltage requirements and operating environment temperature, please refer to the Technical Specifications. Before applying power Verify that the product is set to match the available line voltage, the correct fuse is installed, and all safety precautions are taken. Power requirements: DC 24V/4A. Do not operate in an explosive atmosphere Do not operate the instrument in the presence of flammable gases or fumes. Do not remove the instrument cover Operating personnel must not remove instrument covers. Component replacement and internal adjustments must be made only by qualified service personnel. Instrument that appears damaged or defective should be made inoperative and secured against unintended operation until they can be repaired by qualified service personnel.

Shineway Technologies, Inc. - 3 - Safety Terms Used in This Manual The WARNING sign denotes a hazard. It calls attention to a procedure, practice, or the like, which, if not correctly performed or adhered to, could result in personnel injury. Do not proceed beyond a WARNING sign until the indicated conditions are fully understood and met. The CAUTION sign denotes a hazard. It calls attention to an operating procedure, or the like, which, if not correctly performed or adhered to, could result in damage to or destruction of part or the entire product. Do not proceed beyond a CAUTION sign until the indicated conditions are fully understood and met. Laser Safety Notes  This instrument is a laser instrument. Users should avoid looking directly into the optic output. And the use of microscope or magnifier should also be avoided, for the use of such devices can focus a highly intense beam onto the retina, which may result in permanent eye damage.  Please pull out the SFP modules after using the instrument and make sure to put on the dust cap. Electric Safety Announcements If need to assure instrument thorough outage, please pull up power line and take the battery out  AC/DC adaptor should be used only indoors.  The ambient air of this instrument should be free flow.

Shineway Technologies, Inc. - 4 -  Any using of electric tools near inflammable gas or smog will be a big safety threat.  In order to avoid electric shock, please don’t use instrument if there is damage on any outside surface part(top cover, panel, etc)  Only qualified professional staff can do electrified adjustment, maintenance and repair to the operating instrument.  Even the power is cut off; the capacity in the unit might be electrified in some time after that.