Eswood ES-220 Equipment Manual

2 TABLE OF CONTENTS 1. Installation 1.1. Important: Prior to Installation 3 1.2. Service & Spare parts 4 1.3. Installation 5 1.4. Initial Start-up Procedure 6 2. Washing Operation 7 3. Shutdown and Maintenance 8 4. Trouble Shooting 9,10,11 5. Diagrams 12-13 ...

8 SHUTDOWN AND MAINTENANCE 3 1. When washing is complete turn the rotary switch "OFF". 2. Open the inspection doors and drain the tanks, by lifting and twisting the T-bar lever. 3. Remove the curtains and wash them in warm water 4. Remove the strainer pans and clean them under a tap. Hose the inside of the machine and make sure that all of the water drains out of the tanks. Then remove the strainers from the pump intakes,(in bottom of wash tanks-one per tank-) clean them under a tap, replace them immediately then replace the strainer pans. 5. Chec ...

5 INSTALLATION 1.3 1. Remove the packing materials from the machine, including inside the chambers. 2. Remove the lower panels, position the machine and level by screwing the adjustable feet. 3. Connect the 2” B.S.P. gravity drains via 2” traps to the drain outlets. 4. Connect the hot water to the 1/2” B.S.P. inlet valve, located under the main wash tank, via an isolating valve (supplied by others). The hot water supply must be at least 60OC and between 200 to 400kPa. A pressure reducing valve must be fitted for pressure above 400kPa. The pre ...

4 ESWOOD AUSTRALIA BRANCHES 1.2 For inquiries and access to 24/7 service backup, please call our Toll-Free Number: (Applicable to landline only charges apply for calls made from a Mobile Phone) 1800 013 123 This number will automatically access your nearest State office, or the technician on duty if after hours. After hours charges apply. ...

8 SHUTDOWN AND MAINTENANCE 3 1. When washing is complete turn the rotary switch "OFF". 2. Open the inspection doors and drain the tanks, by lifting and twisting the T-bar lever. 3. Remove the curtains and wash them in warm water 4. Remove the strainer pans and clean them under a tap. Hose the inside of the machine and make sure that all of the water drains out of the tanks. Then remove the strainers from the pump intakes,(in bottom of wash tanks-one per tank-) clean them under a tap, replace them immediately then replace the strainer pans. 5. Chec ...

9 TROUBLE SHOOTING 4 PROBLEM POSSIBLE CAUSE AND REMEDY When machine is (a) Check that main isolating switch is turned on, white pilot turned on and fuses are okay. light does not illuminate (b) Pilot light may be burnt out. If so, replace it (this will not stop machine from operating though). (c) Check control circuit fuse in control box. If blown, check for cause and then replace fuse. Machine will not start (a) Check if main motor contactor has been tripped out. Reset if necessary and check draw current of motor. (b) Check water level in w ...

3 IMPORTANT: PRIOR TO INSTALLATION 1.1 Installation must be carried out according to local regulations by qualified trade persons. Isolating switch(es), shut-off valves etc must be within easy reach of the machine for future service and maintenance requirements. If in doubt call ESWOOD AUSTRALIA or their representative for further information. No responsibility will be accepted for defects or damages by improper installation, for changes to the product not authorised by ESWOOD AUSTRALIA, or for operation outside the technical specifications. ESWOO ...

12 DIAGRAMS 5 DRAWING No. A. CURTAIN LOCATION ES-220/ES-220 BD I-220DBC ...