DXV Randall D35102980 Installation Instructions

INSTALLATION INSTRUCTIONS Product names listed herein are trademarks of AS America, Inc. © AS America, Inc. 2015 S A V E F O R F U T U R E U S E RECOMMENDED TOOLS AND MATERIALS Most of the procedures require the use of common tools and materials, which are available from hardware and plumbing supply stores. It is essential that the tools and materials be on hand before work is begun. M965523 Rev. 1.5 (4/17) Cross Handle Model D35102980 Randall® Exposed Tub Filler with Hand Shower ROUGHING-IN DIMENSIONS: • For reference 8-5/8" (218 mm) 2-3/4" DIA. (70 mm) 1/2" NPT (13 mm) MOUNTING HOLES ARE 1/38" DIA. (35 mm) 2-7/8" (72 mm) 7/8" (23 mm) 5" (126 mm) 2-7/8 " (73 mm) 3-1/8" (80 mm) 6" (152 mm) 30° 3-1/2" (89 mm) 9-5/8" (244 mm) Adjustable Wrench Phillips Screwdriver Sealing Tape Level Channel Locks Tubing Cutter Flat Blade Screwdriver In the United States: DXV One Centennial Avenue Piscataway, New Jersey 08855 Attention: Director of Customer Care For residents of the United States, warranty information may also be obtained by calling the following toll free number: (800) 227-2734 www.DXV.com In Canada: DXV 5900 Avebury Road Mississauga, Ontario L5R 3M3 Canada Toll Free: 1-800-387-0369 Local: 905-306-1093 Fax: 1-800-395-1498 www.DXV.ca In Mexico: DXV Via Morelos 330 Col. Santa Clara Coatitla Ecatepec, Estado de México 55540 Toll Free: 01-800-8391200 www.DXV.mx Thank you for selecting DXV. To ensure that your installation proceeds smoothly, please read these instructions carefully before you begin.

M965523 Rev. 1.5 (4/17) 1 2 INSTALL ESCUTCHEONS INSTALL ROUGH PIPING IMPORTANT NOTICE TO THE INSTALLER! Please check with your local Code Authority for acceptable installation requirements for this Roman Tub set with hand shower. Some local codes may require a vacuum breaker and/or a pressure balanced mixing valve to be installed in conjunction with this product. CAUTION Turn off hot and cold water supplies before beginning. 1-5/8" (41 mm) 1-5/8" (16 mm) CROSS BRACE C/L C/L 1/2" NPT (13 mm) FINISHED WALL OPTIONAL TO FINISHED FLOOR FINISHED WALL FINISHED WALL OFF-SET NIPPLE PIPE BRACE 6" (152 mm) COLD HOT 1 2 2 1 C/L OF SUPPLIES (MIN). C/L TO C/L OF ADAPTER C/L TO C/L OF ADAPTER C/L OF SUPPLIES (MAX.). 6" (152 mm) 1/4" (6 mm) OFF-SET 5-1/2" (140 mm) Figure A. Figure B. Figure C. 6" (152 mm) 6-1/2" (165 mm) 6" ±1/2" (152 ±13 mm) • Determine where the finished wall location will be. This measurement is very important! Note: The rough-in measurement from the finished wall to the end of the off-set nipple is 1-5/8” (41mm). See rough-in illustration below. Figure A. • The C/L of the supplies are 6", ±1/2". Figure B. • Install a cross brace between the wall studs. • Apply thread sealant or Teflon Tape to threads of Hot and Cold supplies connections. Assemble 1/2" (13 mm) NPT SUPPLIES at 6" (152 mm) from center to center. Thread ECCENTRICS (1) into roughed-in 1/2” SUPPLY COUPLINGS (2). Center to center dimension of ECCENTRICS (1) is 6" (152 mm). Figure C. • Finish all wall construction. 6 " (152mm) 1 2 • Thread ESCUTCHEONS (1) flush against finished wall. Make sure ECCENTRICS (2) are level.

M965523 Rev. 1.5 (4/17) 3 INSTALL FAUCET 4 5 CONNECT HOSE AND SPRAY TEST INSTALLED FAUCET • Install SEAL WASHERS (1) into COUPLING NUTS (2). • Thread COUPLING NUTS (2) onto ECCENTRICS (3) and tighten. • Install SEAL WASHER (1) and connect smaller end of HOSE (2) to Outlet Nipple on side of BRACKET (3). • Install SEAL WASHER (4) to conical end of HOSE (5) and attach HAND SPRAY (6). • Fully tighten both connections. • Turn VALVES to “off” position. • With handles in “off” position, turn on water supplies and check all connections for leaks. • Remove HAND SHOWER (7) and operate both handles to flush lines. • Lift HAND SHOWER (7) from BRACKET (8) and direct spray into tub. Remove HAND SHOWER (7) from HOSE (5). Turn DIVERTER LEVER (9) to SHOWER and check all connections for leaks. Replace HAND SHOWER (7) onto HOSE (5). 1 2 3 1 7 8 3 2 4 6 5 9 BATH HAND SHOWER CAUTION The flow rate of this Tub Filler exceeds 20 gallons/minute at higher water pressure. Do not fill bathtub unattended.

M965523 Rev. 1.5 (4/17) MODEL NUMBER D35102980 Randall® Exposed Tub Filler with Hand Shower H960317.XXX HOSE AND SEALS M964600-0070A DIVERTER CRANK ASSEMBLY M970043-XXX0A PLUG BUTTON & SET SCREW A860843.XXX CROSS HANDLE KIT M964598-YYY0A HAND SPRAY HOLDER M964593-YYY0A ESCUTCHEON M964601-YYY0A DIVERTER HANDLE KIT H960136.191 1/2" CARTRIDGE (COLD) H960104.191 1/2" CARTRIDGE (HOT) D35107781.XXX HAND SHOWER M964599-YYY0A SHOWER BASE ASSEMBLY 860682.XXX HANDLE CAP M964595-0070A OFFSET ADAPTOR Replace the “YYY” with appropriate finish code POLISHED CHROME 100 BRUSHED NICKEL 144 PLATINUM NICKEL 150 SATIN BRASS 427