DXV 5004A Installation Instructions

© AS America, Inc. 2017 S A V E F O R F U T U R E U S E - 1 - In the United States: DXV One Centennial Avenue Piscataway, New Jersey 08855 Attention: Director of Customer Care For residents of the United States, warranty information may also be obtained by calling the following toll free number: (800) 227-2734 www.DXV.com In Canada: DXV 5900 Avebury Road Mississauga, Ontario L5R 3M3 Canada Toll Free: 1-800-387-0369 Local: 905-306-1093 Fax: 1-800-395-1498 www.DXV.ca In Mexico: DXV Via Morelos 330 Col. Santa Clara Coatitla Ecatepec, Estado de México 55540 Toll Free: 01-800-8391200 www.DXV.mx RECOMMENDED TOOLS AND MATERIALS Most of the procedures require the use of common tools and materials, which are available from hardware and plumbing supply stores. It is essential that the tools and materials be on hand before work is begun. Thank you for selecting DXV. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain in- stallations may require professional help.) Also be sure your installation conforms to local codes. 760168-100 Rev. B (6/17) Elongated Models: 5004A, 5006A, 5011A Round Front Model: 5004B Slow Close Toilet Seats Plumbers' Putty or Caulking Phillips Screwdriver 1 3 2 4 Hinge Screw Cap Washer Plug Grommet Bolt Flange Bulb Wet this area with water For ease of installation of black rubber grommets, insert steel bolt (capture a few threads), and wet the lower area with some water (soapy water works best). Insert plugs into seat holes in bowl. NOTE: FLANGE MUST REMAIN ABOVE THE SURFACE. DO NOT ALLOW GROMMET TO FALL THROUGH!

760168-100 Rev. B (6/17) 5 7 9 6 8 10 A B REPLACEMENT KIT PART NUMBER 760215.100.XXX DESCRIPTION *Seat Hardware Kit *Includes a set of seat bumpers and all hardware needed for installation of seats. Install rubber washer into hinge. Snap hinges with washer into holes on the bottom of the seat. Place the caps over the hinges. Put screws into seat hinge and tighten using a screwdriver. Place seat back on bowl and click seat onto hinges. Place seat with hinges onto bowl. Align seat with front of bowl. Open the seat and cover. Push both inside buttons to release seat and cover. Pull the seat and cover upwards to take it off the hinges.