West Mountain Radio RIGrunner 4005i Manual 

to memory, and the unit will return to normal operation. Here is an overview of the valid radio frequency regions supported: • FCC – USA. Channels 1-11 valid. • IC – Canada. Channels 1-13 valid. • ETSI – Europe. Channels 1-13 valid. • JAPANB – Japan full access. Channels 1-13 valid. Using the factory reset command (detailed in this manual’s section labeled ‘DHCP Toggle, WIFI networking mode toggle and Factory Reset’) will not change this value back to FCC. If the RIGrunner 4005i is not connecti ...

Screen to view the DHCP client configuration information. This screen displays the current DHCP client configuration. DHCP is a protocol that allows for auto IP address configuration. If enabled, the RIGrunner will attempt to talk to a DHCP server to get IP address configuration automatically. In order to enable this, there must be a DHCP server on the network. Most modern routers have DHCP support. Additional information and details are discussed in the Networking section of this manual. HTTP Port Screen: Press NEXT when viewi ...

connection with a computer. Status Mode: The top line displays the user configured name for this node or power supply. The bottom line displays the status of one node at a time for a few seconds before scrolling to the next node. If the node is enabled, it will display the load (in Amps) drawn from that node. If the node is disabled, it will display OFF in that position. The LCD status screen will continue to display a screen until the NEXT or EXIT button is pressed. If NEXT is pressed it will display the next status screen. ...

The RIGrunner can log unit status, either periodically and/or due to an alarm, to a micro SD card instered by the user. The RIGrunner does not ship with an SD card. To access the SD card receptacle, the top cover of the RIGrunner must be removed. The SD card should be formatted as FAT32. To test the SD card, set ‘Apend Now’ to ‘Yes’ on the Device Setup web- page and then press the Submit Values button. Go back to the main status web-page and click on the ‘Download Log’ link to download the log file from the SD card. Specifications Input Voltage Range min. 8.0V ...