Celexon Expert Installation Manual

Thank you for purchasing this celexon product. Please read the installation instructions carefully before using the screen. Please keep for future reference. EC declaration of conformity Manufacturer: celexon Germany GmbH & Co. KG Address: Gutenbergstraße 2, 48282 Emsdetten, Germany Hereby declare that the following product Product name: celexon electric screen Expert Manufacturer: celexon Germany GmbH & Co. KG 48282 Emsdetten, Germany complies with the following standards: EN 60335-1:2012+A11:2014 EN60335-2-97:2006+A11:2008+A2:2010 EN62233:2008 EN55014-1: 2006+A1: 2009+A2: 2011 EN61000-3-2 EN 61000-3-3 EN 55014-2 Und folgende Brandschutznorm erfüllt: B1 DIN 4102-1 Notes: The tests were carried out in normal mode and refer to the tested device under the specified tests. This certificate applies only to the devices tested. Emsdetten, 09.03.2016 Christoph Hertz Managing Director www.celexon.com [email protected]

220V ~ 240V, 50Hz Power consumption: 130W (max.) 0,4W (standby) Install the screen so that it is central for most viewers. When fully extended, please ensure that the lower third is about eye level. The screen can be wall or ceiling mounted (You may be required to purchase screws and wall plugs suitable for your specific building material, use Ø ca.5x35mm screws). Ceiling installation Mark out two parallel lines with the appropriate hole spacing of the mounting brackets on the ceiling. Ensure that they are aligned and drill the holes. Screw the mounting brackets to the ceiling (see fig 1). Then hang the screen on the brackets (see fig 5) and tighten the safety screw underneath the screen (see fig 6). Fig 1: Mounting brackets attached to ceiling Fig 2: Side view of ceiling installation Fig 3: Mounting brackets attached to wall Operating instructions Plug power cable into socket (ensure correct voltage). Position the cable so that it does not present a hazard or comes into contact with any hot surface. You may require an extension lead. To lower the screen Press the down arrow button. The screen will come down and stop automatically at its default stop position. To retract the screen Press the up arrow button. The screen will automatically retract into its housing and stop at the upper default stop position. To stop the screen Press the stop button (between the arrows) and the screen will automatically stop. It is possible to adjust the stop positions. Please contact your dealer or email [email protected] for written instructions. 2 Wall installation Mark out two parallel lines with the appropriate hole spacing of the mounting brackets on the wall. Ensure that they are aligned and drill the holes. Screw the mounting brackets to the wall (fig 3). Next, hang the screen on the brackets (see fig 5) and tighten the safety screw underneath the screen (see fig 6). Fig 4: Mounting bracket Fig 5: Side view of screen attaching to mounting bracket Fig 6: Safety screw