Ceragon FibeAir IP-20 All-Outdoor Series Operation & User’s Manual

Page 910 of 945 Ceragon Proprietary and Confidential 1778 rfu-power-decreased-due-to- pa-temp Alarm Equipment RFU power decreased due to PA temperature Major Defective RFU (the RFU cannot transmit the requested TX power). 1. Replace RFU. 2. Intermediate solution - reduce TX power. 1780 mrmc-running-script-deleted Event Equipment MRMC running script is deleted Warning New installed software package does not include the running MRMC radio script 1. Make sure the required software package include the running MRMC radio script. 2. Do ...

Page 919 of 945 Ceragon Proprietary and Confidential 2100 STM-1-OC-3-IN-LOS Alarm Equipment Loss of Signal on Line Interface (LOS) on STM- 1/OC-3 port. Critical 1. Line is not properly connected. 2. External equipment is faulty. 1. Reconnect line. 2. Check line cables. 3. Check external equipment. 2101 STM-1-OC-3-IN-LOF Alarm Equipment Loss of Frame on Line Interface (LOF) on STM- 1/OC-3 port. Major 1. Line is not properly connected. 2. External equipment is faulty. 1. Reconnect line. 2. Check line cables. 3. Check external equip ...

Page 441 of 945 Ceragon Proprietary and Confidential 4 In the Profile field, select a User Profile. The User Profile defines the user’s access levels for functionality groups in the system. See Configuring User Profiles. 5 In the Password field, enter a password for the user. If Enforce Password Strength is activated (see Configuring the Password Security Parameters), the password must meet the following criteria: ◦ Password length must be at least eight characters. ◦ Password must include characters of at least three of th ...

Page 263 of 945 Ceragon Proprietary and Confidential 5.1 Viewing the Radio Status and Settings You can configure the radios and display the radio parameters in the Radio Parameters page. Note: For instructions how to configure the radio parameters, see Configuring the Radio Parameters. To display the radio parameters: 1 Select Radio > Radio Parameters. The Radio Parameters page opens. ◦ For multi-carrier units, the Radio Parameters page initially displays a table as shown in Figure 189. ◦ For single-carrier units, a page appe ...