CDI CD42-STS Operation & User’s Manual

Page 19 of 36 CAUTION: The end plate is heavier than it looks; be careful not to damage the O-ring or circuitry under the plate. Do not bump or drop the end plate. Avoid straining the ribbon cable or cable connections. Carefully disconnect ribbon cable connector from circuit board on end plate. ...

Page 17 of 36 This method relies upon the physics of the coupling between the magnetic transmitter inside the pipeline and the receiving antenna on the outside of the pipeline. SIGNAL “NULL” COIL CENTERLINE ...

Page 33 of 36 Care and Maintenance Equipment designed by CDI is protected against the environment in which it is intended to operate. Much of the equipment is designed for prolonged use in the field without any special maintenance other than routine battery replacements. It is the Purchaser’s responsibility to insure that proper precautions are taken during installation and operation so that weather seals are in place, routine maintenance occurs, etc. Failure to perform these operations nullifies this warranty. CDI equipment should o ...

Page 32 of 36 Warranty All equipment sold by Control Devices, Incorporated (CDI) is warranted for a period of one (1) year from the date of shipment to Purchaser, providing the instrument or equipment has not been modified, abused, or used for purposes which it was not designed for. Batteries, probes, leads, magnets, and other consumables subject to wear are not covered by this warranty. CDI will repair or replace faulty equipment during the warranty period when the cause is a defect arising from faulty design, materials or workmanship ...