IAdea PTM-101 Quick Start Manual

Quick Start Guide This printed quick guide provides a quick walkthrough of the set up process. Technical Spec Net weight 0.4 kg (0.88 lbs) Dimension (W * H * D) 116 mm x 116 mm x 66 mm (4.56" x 4.56" x 2.59") Screw type M4 Material Steel Hinge module Tilt Torque adjustment -5° ~ 20° (free angle) Available Display support Mounting pattern Panel size support Support weight 100 mm x 100 mm / 75 mm x 75 mm / 50 mm x 50 mm < 28" 15 kg (33.06 lbs) Distance to wall 66 mm (2.59") Safety lock N/A Anti-theft lock N/A Box Content Item Parts Q'ty 1 Wall Bracket 1 2 Fixed Plate 1 3 Washer ( 1/4") 2 4 Spring Washer ( 1/4") 2 5 Screw (RH 1/4" - 2 UNC * L 5/8") 2 6 Screw for monitor (M4 * P0.7 * L 12mm) 4

- for wooden structure, self-tapping screws are recommended. - for brick structure, use 7.5 mm drill bit to open a 50 mm depth hole to hammer in wall anchors, then install screws. Self-tapping screws are recommended. Mounting and Installation 2 Install Screw for monitor (6) into the Fixed Plate (2) to lock the the mount screw-holes located at the back of the digital signage. 3 Hook the bar on the back of the Fixed Plate (2) on to bar holder at the top of the Wall Bracket (1). 4 Place one of the Screws (5) through a Spring Washer (4), a Washer (3), and then insert it through the hole on one side of the Wall Bracket (1), with Fixed Plate (2) hooked. 5 Repeat step 4 to complete installing the other side of the Wall Bracket (1), with Fixed Plate (2) hooked. 6 Adjust the tilt of the Fixed Plate (2) to the angle desired and then fasten the Screws (5) on both sides of the Wall Bracket (1), with Fixed Plate (2) hooked, to complete the PTM-101 mounting installation. Product Photos PTM-101 intalled Hooking Fixed Plate (2) to Wall Bracket (1) Screws (5) through a Spring Washer (4), a Washer (3) Digital signage tilted upwards Digital signage tilted downwards