RCI 0161 Installation

2) Mark the mounting holes for the Double Door Housing (DDH) on the inactive door. 3) Drill two 13/32” (0.406”) holes through inactive door. 4) Drill wire access hole into desired area of DDH. Pull two (2) wires through the access hole and connect to strike. (Polarity is not observed) 5) Temporarily mount 0161 strike to DDH through the slotted holes (Hole C) using 1” button head socket cap screws. (BHSCS) 6) Mount DDH to inactive door using the two (2) 1/4-20x3” screws and 1/4-20” Sex Nuts supplied. 7) Adjust electric strike insert horizontally (If necessary), until Pullman Latch engages when door is closed. (See Fig. 2 on 0161 installation instructions if further horizontal insert adjustment is necessary) 8) Mark, drill and tap Hole D for 1/4-20x1” BHSCS provided to secure the final location. I N S T A L L A T I O N 0161 Double Door Housing IS0161DDH PCN110045 R07/11SH ® ©2011 RUTHERFORD CONTROLS INT’L CORP. WWW.RUTHERFORDCONTROLS.COM USA: 2517 SQUADRON COURT, SUITE 104, VIRGINIA BEACH, VA 23453 • CANADA: 210 SHEARSON CRESCENT, CAMBRIDGE, ON N1T 1J6 PHONE • 1.800.265.6630 • 519.621.7651 • FAX: 1.800.482.9795 • 519.621.7939 • E-MAIL: [email protected] A 7/8 .875 22.22 B 3-1/2 3.500 88.90 MEASUREMENT FRACTIONAL INCHES DECIMAL INCHES METRIC (mm) 13/32” (0.406”) 13/32” (0.406”) CL A B B

Typical Double Door Housing Assembly Double Door Housing Typical Surface Exit Device ©2011 RUTHERFORD CONTROLS INT’L CORP. WWW.RUTHERFORDCONTROLS.COM USA: 2517 SQUADRON COURT, SUITE 104, VIRGINIA BEACH, VA 23453 • CANADA: 210 SHEARSON CRESCENT, CAMBRIDGE, ON N1T 1J6 PHONE • 1.800.265.6630 • 519.621.7651 • FAX: 1.800.482.9795 • 519.621.7939 • E-MAIL: [email protected] 0161 DOUBLE DOOR HOUSING ACTIVE DOOR EDGE DEADLOCKING TRIGGER LATCH CL CL CL CL A B B DOOR FACE INACTIVE DOOR EDGE SCREW 1/4-20 X 3” STRIKE INSERT DRILL 13/32” HOLE (2 PLACES) ACTIVE DOOR EDGE TYPICAL SURFACE EXIT DEVICE SEX NUT 1/4-20” HOLE C SCREW 1/4-20 x 1” HOLE D SCREW 1/4-20x1” HOLE D SCREW 1/4-20x 1” HOLE C SCREW 1/4-20x 1” INACTIVE DOOR NOTE: Not to scale. Specifications are subject to change without notice.