RCA RTU7877 Instruction Manual

and retain it for future reference. 1: US Model: RTU7877 Law“ "This product is manufactured and sold by Curtis International Ltd. RCA, the RCA logo, the two dogs (Nipper and Chipper) logo, are registered trademarks or trademarks of RCA Trademark Management and are used under license by Curtis Internationa| Ltd. Any other product, service, company, trade or product name and logo referenced hereinare neilherendorsed nor sponsored by RCATrademark Managementor its affiliates."

Remote Control FrontVlew Side Vlew BackView“ Installation C, Antenna Connectio AV Connectlon YPbPr Connectlon HDMI Connoctlon Power Cord Connection Optlcnl audlo output Connootlon PufllngTho Unlt OnA ProperPlace Turnlng The Unit On ForThe FirstTime Source Selection TV(CHANNEL) Menu Picture Menu Sound Menu Time Menu Setup Menu LOCK(Parental) Menu Hopi. mounts V snocnue GUIDE ‑ \ Video Formats TV Symptom

OF THE APPARATUS. CAUTION RISK OFELECTRIC SHOCK DO NOT OPEN DO NOT EXPOSE THIS UNIT T0 RAIN 0R MOISTURE AVIS HISflUE DECHOC ELECTRIOUE-NE PAS OUVRIH WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE COVER ( O R B A C K ) NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, A within an equilateral triangle,is intended to alert the user to the presence of uninsulated "dangerous voltage"within the product's enclosure that may beof sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral A Triangle is intended to alert the user to The presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance, ACAUTION ' DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE. ' USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED MAY RESULT IN HAZARDOUS RADIATION EXPOSURE A WARNING: 0TO REDUCETHE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. TO REVENT FIRE OR SHOCK HAZARD, DO NOT ° EXPOSE THIS UNITTO RAIN OR MOISTURE DO NOT PLACE OBJECTS FILLED WITH LIQUIDS ON OR NEAR THIS UNIT. ' SHOULD ANY TROUBLE OCCUR. DISCONNECT THE AC POWER CORD AND REFER SERVICING TO A QUALIFIED TECHNICIAN. electrical appliance. It has been designed in such a way that it does not require a safety connection to electrical earth. E This equipment is a Class II or double insulated - Do not use this unit in places that are extremely hot, cold, dusty or humid. - Do not restrict the airflow ofthis unit by placing it somewhere with poor airflow, by covering it with a cloth, by placing it on bedding or carpeting. SAFETYINFORMATION ° When connecting ordisconnecting the AC power cord, grip the plug and notthe cord itself. Pulling the cord may damage it and create a hazard. ' When you are not going to use the unit for a long period of time, disconnect the AC p O W e r cordt RATING PLATE LOCATION The rating plate is located on the rearot the unit. FCC STATEMENTS NOTE: This unit has been tested and found to comply with the limits for a Class 8 digital device, pursuant to Part 15 ofthe FCC Rules These limits are designed to provide reasonable protection against hatrntul interference in a residential installation. This unit generates, uses and can radiate radio frequency energy and, it not installed and used in accordance with the instructions. may cause harmful interference to radio communication. However.there is no guarantee that interference will not o c c u t in a particular installation. It this unit does cause harmful interference to radio or television reception,which can be determined by tuming the unit off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocatethe receiving antenna - Increase the separation between the unit and receiver‘ -Connect the unit into an outlet on a circuit different from that to which the receiver is connected - Consult the dealer or an experienced radiolTV technician for help A WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the unit. HEIITII" ma» ncrmmau MULTIMEDIA I m a m "HDMI. the HDMI logoand High‐Definition Multimedia Interface are trademarks or registeredtrademarks of HDMI Licensing LLC.‘ 1)Read these instructions. 2)Keep these instructions. 3)Heed all warnings. 4)Follow all instructions. 5)Do not use this apparatus nearwater. 6)Clean only with a dry cloth. 7)Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. 8)Do not install near any heatsources such as radiators, heat registers,stoves. or other apparatus (Including amplifiers) that produce heat. 9)Donotdefeatthe safety purpose0! the polarized 0t grounding-type plug. A polarized plug has two blades with o n e wider than the other. A groundingtype plug has two blades and a third grounding p r o n g t The wide blade or the third prong is provided fot your satety. It the provided plug does not tit into y o u t wall outlet, consult an electrician for replacement of the obsolete outlet. 10)Protect the power cord from being walked on or pinched particulatly at plugs,convenience receptacles. and the pointwhete they exit trorn the apparatus. 11)0nly use attachments / accessories specified by the manufacturer. IMPORTANTSAFETY INSTRUCTIONS 12)Use only with the cart. stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart / apparatus combination to avoid injury from tip-over. 13)Unp|ugthis apparatus during lightning Storms or when unused for long periods of time. 14)Refer all servicing to qualified service personnel. Servicing is required when the apparatushas been damaged in any way, such as the power cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped 15)The mains plug is used as disconnect device, the disconnect device shall remain readily operable. o 8 fl}

Remote control . . . . x 1 Battery(AAA) .................................................................................................................x2 Warranty Card ................................................................................................................x1 Instruction Manual . ...x1 Base stand and 4 base stand screws GETTING STARTED USING THE REMOTE CONTROL ~Pointthe remote control at the remote sensor located on the unit‘ ‘When there is a strong ambient light source, the performance ofthe infrared { e m o t e s e n s o t V ‘ m a y be degraded, causing unreliable operation. -Therecommended effective distance for remote operation is about 16feet(5 melets) T0 INSTALL THE BATTERIES 1.0pen the battery door. 2. Insert 2"AAA"batteries. BATTERY REPLACEMENT When the batteries become weak, the operating distance ofthe remote control is greatly reduced and you will need to replace the batteries. ACAUTION : Danger of explosion if battery is incorrectly replaced. NOTES -If the remote centre! is not going to be used inr mlong llme, remove the batteries to avoid damage caused by battery leakage corrosltm -Do not mix old and n e w batteries. Do not mix Al KAI INF, ntnndnm (CARBON-ZINC)or rechargeable (NICKEL-CADMIUM) batteritm 'Always remove batteries as soon as they buumnn wmck -Weak batteries can leak and severely dnnmmu thn ummta mmlml WARNING: Do not dispose batteries in a fire. Bultumm I n n y nxplmia 0r Innk. Batteries shall not be exposed to oxmnmtvu iumt aunt: ml Iunuhlno, [Ire orthe like. @9 @ C : ) @ ‑ --‑ POWEFNO): Tu m s m e N m o r o l l . MUTE ( l a y m v a o t - m l o Itsmnumm m a t h e s s a g a ‘ m t o restore m e v m m t NUMBERBUITONS: P l fl i079 select a W channel aiecuy when you are w a l a m g I v . ‘ ‐ / ‐ - 't To switch the channel digit R e a l1%): Returnsto me p a w n s channel AUDIOASwllch mo audlochannel in TV mode F A V - J F A V } ; S a l u p 01‘ man" I ’ m Illac a l m ! lavailec h m Inst FAV: M a s “ m m m m m m m l m fl e liegoralasesmeoment channel m w m fi m fl k m fl b a m m m ) , M + q u ‐ : h m w m fi e w m m c m orCH‐ : m m u m m m w m u . M m m w m m m a m m m w w m m m W m m m m m m . m m m m m m m m m m m m m m Uselhaamwslohighlight m m m m m m m m m m m .m m m W fl m a fl m t i c a l l y ‘ NOTE: Format : NEC Customer code :A05F Code location Chart I LOGO Color: Pantone 877C LOGO SIZE: 16.9x5mm LOGO align center ‘g_s_m__ ‘ LOGO COLOR: PANTONE a77c “ e l l g LOGO SIZE: 1eisx5mm LOGO ALIGN CENTER ASPECT: Switches between the preset screen size mode. INFO: Press to display the current program information on the screen, Arrows ( 4 / > /A / v ): Uses the tour anows to highlight diflerent items in the TV menu or change the value, OK: Enter and confirm buttont MENU: Accesses the Maln Menu, or return (0 the upper level of a sub-menut EXIT: Exits the current menu or tunction. CH.LIST: List adecanales. EPG: Shows Electronic Program Guide(use in the DTV mode). PLAY/PAUSE: Play or Pause media files STOP:SIop playing mediafiles. FR ( F F. Fast review of fast forward. PREV INEXT: Select the previous or next media fi l e . CC: Selects the closed caption MTS:SeIect the multi-channel television sound. FREEZE: Freeze the current screen frame, press again to retum to normal. REPEAT: Selecl the previous or next media file. RED/GHEEN/YELLOW/BLUEzThese control function of these buttons d o not apply to this model, 9 All pictures in this manual are examples, only for reference, actual product may differ from the pictures. 0 The buttons not mentioned here are not used.

CONTROL REFERENCEGUIDE FRONTVIEW About remote control working distance and angle, see next page. Power/Standby Indicator: Blue and red duaI‐cotor LED. It shows red when the TV is turned off and bluewhen turned on. Remote Control Sensor: Remote contro IRsensor, which receives infrared ray sent by remote control. BACKVIEW Remote Control Sensor Power/Standby Indicator lltllllllllttllllll SIDEVIEW n r w n w u n n m : OPTICAL: Connect to an external digital audio device CVBS: Connect an AV device that has composite video jacks, such as a VCR or DVD player. ° L: Left audio channel connection. 0 R: Right audio channel connection YPbPr: Connect a device that has component video jacks,such as a DVD player. Line Out: Connect external amplifiers here, Note that connecting external amplifiers will INPUT: Displays the Source Select List mute the sound from the Tv’s built-in speakers. MENU: Displays the TV Main Menu. CHA: Scans up through the channel list. Inthe TVmehu system. it acts like the up arrow on the remote control and can be used to select menu options. CHv: Scans down through the channel list. In the TVmenu system. it acts like the down arrow on the remotecontrol and can be used to select menu options. VOL+: Increasesthe volume. In the TV menu system. It acts like tho rlght arrow on the remotecontrol and can be used to select menu options. ‑ VOL-: Decreases the volume. In the TV menu system, It ucln llku lhu lull urrow on the remotecontrol and can be used to select menu options. POWER ( 0 ) : Turns the TV on and off. HDMl1/2l3/4:Select HDMl1/HDM'l2/HDMl3/HDMI4source input. RF: Connect the antenna USB Media Player:Connect USB device, such as flash disk to access media function of TV. (Supportformat: TXT for Text. MP3for music. JPG, JPEG, BMP and PNG for photo). NOTE: It can not play videoformat.