Webasto MultiControl Installation Instructions Manual

14 8 Technical Data Control element MultiControl / SmartControl UniBox Nominal voltage [V] 12 to 24 Maximum power consumption (during operation without external relay) [mA] 17 to 23 12 Maximum power consumption (in standby) [mA] 0.5 Admissible ambient temperatures [°C] (operation / storage) -40 to +75 / -40 to +90 Dimensions of control element [mm] (length / depth / height) 68 / 15 (9.5 without control knob) / 48 90 (104 with connected wiring harness) / 60 / 25 Weight [g] 41 66 ...

2 Table of Contents 1 About This Document 3 1.1 Purpose of the document 3 1.2 Documents supplied 3 1.3 Use of this document 3 1.4 Use of symbols and highlighting 3 1.5 Liability waiver 3 2 Safety 4 2.1 Intended use 4 2.2 Qualification of the installation personnel 4 2.3 Regulations and statutory provisions 4 2.4 Safety instructions 4 3 Device Description 5 3.1 Delivery scope 5 3.2 Identification plate 5 3.3 Description of Functions 5 3.4 Device versions 5 3.5 Use 5 4 Installation of the Control Element 6 4.1 Recommendations for installation 6 4.2 Requiremen ...

7 Optional installation with holder 1 2 4 3 Fig. 03: Install control element with holder 1 Installation location 2 Holder 3 Screws 4 Control element X X Determine the installation location. X X Determine the location for the leadthrough of the control ele- ment wiring harness. X X Install the holder using the screws supplied. X X Lay the control element wiring harness through from the front. X X Clip the control element into the holder. Observe the statutory regulations when installing in cars. 1 2 Fig. 04: Connection example control element (1) with heat ...

Webasto Thermo & Comfort SE Postfach 1410 82199 Gilching Germany Visiting Address: Friedrichshafener Str. 9 82205 Gilching Germany The telephone number of each country can be found in the Webasto service center leaflet or the website of the respective Webasto representative of your country. In multilingual versions the German language is binding. ...

12 7 Fault Remedy 7.1 Error code If a fault occurs in the heater during heating, the heater outputs an error code via the control ele- ment. Further information can be found in the instruction manual of the heater. Internal control element error table "Txx" A fault is signalled as Txx or as Fxx on the display of the control element together with the red flashing LED. The fault display also appears after waking up the control element from standby mode and must be acknowledged by pressing the control knob or the quick-start knob. This fault is stored in the e ...

Webasto Thermo & Comfort SE Postfach 1410 82199 Gilching Germany Visiting Address: Friedrichshafener Str. 9 82205 Gilching Germany The telephone number of each country can be found in the Webasto service center leaflet or the website of the respective Webasto representative of your country. In multilingual versions the German language is binding. ...