Havis C-DMM-3004 Installation Instructions

2014-2020 Dodge Durango TOOLS REQUIRED: Ratchet Wrench Dash panel removal tool Open End Wrench - 7/16” Socket Set Phillips screwdriver Always!  Read all instructions before installing any Havis, Inc. products.  Check for obstructions (Wires, brake lines, fuel tank, etc.) before drilling any holes!  Use hardware provided with install kit HARDWARE and PARTS: QTY DESCRIPTION PART# 2 Upper support bracket CM009333 2 Side support bracket CM009334 4 10-32 x 1/2" Machine screw GSM33118 4 #10 Flat washer GSM31003 2 10-32 Keps nut GSM30028 1 VESA rotator plate CM010471 2 1/4" x 3/4" Carriage bolts GSM32000 1 PVC washer (2.875” diameter) CM010648 2 1/4" Plastic washer CM86600 2 1/4" Steel washer GSM31005 2 1/4" Nylock nut GSM30016-1 Notes: The C-DMM-3000 swivel plate accepts C-MM-301 offset bracket used with C-MM-2XX adaptors. C-MM-2XX series adaptor brackets are not needed for most VESA 75 and other Havis Docking Station mounting applications. CM010471 VESA rotator plate gives additional positioning options, but is not required depending on mounting preference.

GSM33118 10-32 x 1/2” Machine screw GSM31003 #10 Flat washer GSM33118 10-32 x 1/2" Machine screw GSM31003 #10 Flat washer CM009334 Side support bracket GSM30028 10-32 Keps nut CM010471 VESA rotator plate CM010648 PVC washer CM86600 1/4" Plastic washer GSM31005 1/4" Steel washer GSM30016-1 1/4" Nylock nut GSM32000 – 1/4"x 3/4"Carraige bolt

Carefully reinstall trim bezel / panel assembly with four brackets protruding out of gap between bezel and dash. Repeat process for lower side support brackets. Brackets go behind the OEM screen mounts. Carefully remove trim bezel / panel assembly using plastic panel tool. Remove (4) 7mm head fasteners around OEM screen. Attach the upper support brackets behind the OEM screen mounts and reinstall fasteners. Remove trim panel and set aside.

x 1/2" screws and washers at the top and 10-32 x 1/2" screws, washers, and keps nuts on the side. Installation is now complete. Double check all hardware, latching and wire harness clearance. Position VESA plate on back of Device as desired. Attach VESA plate with carriage bolts to the back of the dock. The gray PVC washer will go between this bracket and the DMM swivel plate. Attach the dock to the mounting bracket (with hardware supplied with dock) and run wires as desired. Determine desired position for your specific computer and attach to DMM swivel plate using 1/4"x 3/4” carriage bolts, PVC spacer, nylon washers, steel washers, and nylock nuts. Tighten so that the dock rotates smoothly.