Flux Beambox Operation & User’s Manual

If the machine menu is blank when clicking on the camera button, it means the connection between the computer and the machine was not set up properly. Check "Cannot Connect to the Machine" (p.101). 3.3 Importing the Test File Click on Menu > File > Samples > First Engraving. Click on Export, select your machine and click Start to start the task. all-guides com ...

It is recommended that the film should remain on the acrylic when processing, unless engraving greyscale images. Use an alcohol swab to clean the acrylic, please note that too much may cause other surface defects. 5.5 Paper ・How To Reduce Burn Edge On Paper When cutting white paper, it is easy to produce a yellowish carbonized burn edge. The use of universal clay or other low-viscosity substances can effectively remove the toner to a cer t ain ex tent without damaging the surface of the paper. ・Corrugated Cardboard When cutting corrugated paper, the cardbo ...

If there is no laser output when Beambox is running and the machine is making a loud cracking sound, it indicates the tube is broken. Please stop operating the machine to prevent further hardware failure. If you do not hear the cracking sound, please check the following: 1 Open the back lid, refer to 7.7 Laser Tube Replacement (p.77) for instructions. 2 Go to touch panel > Maintenance, make sure power is set to "x1.0" then close the front door. Press “Laser Pulse” and observe if a pinkish fluorescent light is emitted through the laser tube. If yes, it means the ...

▲ Check if the wire is firmly clamped by the terminal all-guides com ...

too powerful. Choose thick glass materials for better flexibility. 5.7 Metal ・Anodized Aluminum Anodic treatment is a surface treatment that forms an oxide layer on the aluminum alloy. Through laser engraving, the sur face oxide layer will be decomposed. ・Stainless Steel (with coating) Due to the wavelength of CO2 lasers, stainless steel reflects most of the energy, so special oxidants are needed to allow the stainless steel to oxidize and darken at relatively low temperatures and darken the color. Wear work gloves when app ...