EOS SBM GLT KNX Installation And Operating Instructions Manual

Mounting and electrical installation EN 4.3 Configuring addresses for multi-cabin installations You only need to configure S bus addresses in a multi-cabin installation with an EmoTouch 3 control unit. The S bus address of the cabin you want to control must be configured in the KNX Home-Modul for this purpose. The Emotec, EmoStyle, EmoStyle i, Emotec IR, InfraStyle and InfraStyle i always require the cabin address 1. Programming the address 1 Keep the programming button pressed for approx. 5-6 seconds until the red LED lights up. � ...

9 Identification 2.2 Intended use The KNX Home module is intended to be connected to a building manage- ment system. It serves to remotely control selected functions in sauna cab- ins, infrared cabins and steam rooms. The following control units support this control: Emotec, Emotec IR (software release R. 3.44 or higher) EmoStyle, InfraStyle (software release R. 3.44 or higher) EmoStyle i, InfraStyle i (software release R. 3.44 or higher) EmoTouch 3 (also SteamRock Premium, software release R. 2.08 or higher) Check the softwa ...

General safety instructions EN General safety instructions 1.1 Safety levels Safety instructions and important operating instructions are clas- sified according to ANSI Z535.6. Please familiarise yourself with the following terms and symbols: DANGER Danger Indicates a hazardous situation which, if not avoided, will result in death. WARNING Warning Indicates a hazardous situation which, if not avoided, could result in death or serious injury. CAUTION Caution Indicates a hazardous situation which, if not avoided, could result in minor or ...

25 Mounting and electrical installation 5 Select the KNX Enable checkbox. You are not required to set any further values for the KNX transfer protocol. 6 Confirm your setting with . Enable ONE NONE 1200 19200 Enable 30 Disable TWO ODD 2400 38400 Disable EVEN 4800 57400 9600 115200 Stop bits Parity Baud Rate Address KNX Modbus Settings 27. August 2018 09:16:42 ...

Description of the unit EN Description of the unit The KNX Home module allows you to monitor and control cabin-control functions using a building management system. This enables monitoring of individual cabins or a complete multi-cabin installation. In a multi-cabin installation, a KNX Home module is connected for each cabin. The KNX Home module transfers data between the sauna bus and the KNX bus in both directions. Its use is configured using the building manage- ment system. The KNX Home-Modul should be operated with software ver- ...

Mounting and electrical installation EN Advanced installation In the case of a multi-cabin installation with the EmoTouch 3 control unit, the KNX Home-Modul must be installed in the same S bus seg- ment as the relay box that is to be controlled. It may also be necessary to use an S bus plug-in module. The S bus address of the cabin to be controlled must be configured in the KNX Home-Modul. 4.2.1 Connecting the S bus cable to the relay box or module NOTICE Incorrect data transfer due to incorrect installation The software does no ...

Service address Store this address with the Installation and Operating Instructions in a safe place. Please always provide us with nameplate data, such as model, item num- ber and serial number so we can provide fast and efficient support. Date of sale Stamp/retailer signature: EOS Saunatechnik GmbH Schneiderstriesch 1 35759 Driedorf, Germany Tel. +49 2775 82-0 Fax +49 2775 82-431 Web www.eos-sauna.com ...