Winmate M101B Quick Installation Manual

5 Hardware Installation This section describes the OPS module and display installation procedures. OPS module slot is located on the rear side of the display. Hardware installation steps: 1. Disconnect the AC power source from the Display, and make sure the system is powered OFF when you insert the OPS module. 2. Match the OPS module slot position with the Display. 3. Insert the OPS module to the slot on the rear side of the Display. 4. Fasten two Phillips M3x5 mm round head screws to fix OP ...

3 OPS Module and Display Quick Start Guide Important Safety Instructions Please read the following instructions carefully. 1. Unplug the display if you are not going to use it for an extensive period of time. 2. Keep the display out of direct sunlight and away from stoves or any other heat source. 3. Keep the display dry. To avoid electric shock, do not expose it to rain or excessive moisture. 4. When positioning the display, make sure the power plug and outlet are easily accessible. 5. The ...

3 OPS Module and Display Quick Start Guide Important Safety Instructions Please read the following instructions carefully. 1. Unplug the display if you are not going to use it for an extensive period of time. 2. Keep the display out of direct sunlight and away from stoves or any other heat source. 3. Keep the display dry. To avoid electric shock, do not expose it to rain or excessive moisture. 4. When positioning the display, make sure the power plug and outlet are easily accessible. 5. The ...

pluggable module into the display panel. This quick start guide tells you step-by-step instruction on how to install OPS module to the display. You will find instructions for the following procedures:  Unpacking  Hardware Installation  Display Input Signal Settings  Power Management Settings  Winmate Model Combinations  Sealing Surface Acoustic Wave Touch Screen Unpacking This product is packed in a carton, together with the standard accessories. Any other opt ...

Windows OS In OPS mode the power control of the OPS module is influenced by display's OSD or remote control. Pressing the power button on the OSD panel or remote control will control the OPS Module at the same time (default setting is “shut down”). If you want to change power management settings follow the steps below. 1. Go to > Control Panel > System and Security > select Power Options 2. In the menu on the top left side of desktop select Choose what the power buttons do ...

11 Winmate Model Combinations You can purchase digital signage system, including display and OPS module from Winmate. This section describes Winmate model combination, and includes some notes on each case. Case I Purchase digital signage system (touch display and OPS module) from Winmate Diagram: Note: 1. In this case touch USB signal is set to go through internal OPS connector. Case II Purchase only touch display from Winmate Diagram: Note: 1. USB touch interface only. 2. Touch USB signal i ...