WAGNER 705 Manual 

SAFETY INSTRUCTIONS • Stay clear of steam, hose, hose fittings and steam plate surface. DO NOT place hand in front of steam plate. • Water drops are hot and may burn skin. Use extreme caution when using steam plate overhead, and routinely empty water from steam plate. Wear eye protection and gloves when using this steamer. • Allow parts to cool before changing accessories and /or opening fill cap. • Never point steam plate at anyone. • DO NOT over fill water container. • DO NOT strain or kink hose. Replace hose if it is cracked, worn, or damaged. Never repair a damaged hose. • Power cord must be connected to grounded (3 prong) outlet. • DO NOT use the unit if the power cord is worn or damaged. • Never repair a power cord. • DO NOT pull water container by power cord. • DO NOT allow water or steam to enter light switches or sockets. • DO NOT stand or sit on water container. (Use a step ladder.) • DO NOT modify parts or components. Never repair damaged or worn parts. • Water container must rest on a sturdy, level surface and in upright position. • Keep power steamer away from children. • NEVER leave power steamer unattended. • Read all instructions and warnings before each use. GROUNDING INSTRUCTIONS This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This product is equipped with a cord having a grounding wire with an appropriate grounding plug. The plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and ordinances. WARNING! — Improper installation of the grounding plug can result in a risk of electric shock. SET-UP/USEAGE 1 Fill with clean tap water. Do not exceed water level shown. Water container must rest on a sturdy, level surface and in

full container will operate for about 70 minutes. 2 Line up notch in hose receptacle (a) with the guide on the hose (b). Insert hose and turn clockwise approximately 130º. Hand-tighten locking nut. DO NOT cross-thread the locking nut. Connect other end of hose to the steam plate. Hand tighten fitting onto plate. 3 Connect matching end of cord to the steamer. Plug in the power cord. Once the power cord is plugged in, it will take about 12-15 minutes to produce steam. do not leave steam plate unattended, or face down on any surfaces. Make sure steamer is placed on a sturdy, level surface. 4 For best results, use a scoring tool or a putty knife and gently score the wallpaper in a crisscross pattern. The perforations will allow the steam to penetrate the wallpaper. Once steam is flowing out of the steam plate, hold the steam plate flat against the scored wallpaper for about 10 seconds. Move the steam plate to a new section and remove the steamed section with the scraper blade. 5 do not operate the steamer once the water container is empty. To refill, unplug power cord and let steamer cool for 2 minutes. Slowly remove steam hose and refill the container. Replace hose, plug in power cord and allow unit to reheat. STORAGE 1 Unplug the steamer from the power source. Wait a minimum of 2 minutes and slowly open the hose connection. Drain remaining water from the container. Never store the unit with water in the container.