Vax ECR2V1P Troubleshooting Manual
Text of the manual
Here is what you can do to keep your appliance performing at its
best.
How do I access the brushbar?
Accessing the belt and brushbar
Switch the machine off and unplug from the
wall socket
Remove the tanks and lie the machine back
Remove the 8 screws underneath
Lift the belt cover off
If damaged, remove the belt
Replace with new belt
How do I clean the dirty water tank?
Cleaning the dirty water tank
Press the release button and pull to remove the dirty
water tank
Unplug the cap and empty the tank
Rinse with warm water
Allow the tank time to dry
Is there a high pitched noise coming from the machine?
The machine has a float in the dirty water tank that is designed to rise with the
level of the water. However, if the machine is jolted, or there is a large amount of
foam in the tank, the float may rise to the top. The rising float will block the
suction and the machine will make a high pitched noise.
To return the float to its original position, simply switch the machine off, allow it
to drop down and then try again
No water delivery through the main machine?
Remove and fill the clean water tank
Hold the clean water tank over the sink and press the valve at the bottom of the
tank
A replacement clean water tank is required, go to 'Spares' tab above
Yes?
Re-fit the clean water tank back on the machine and try again
Has the machine been without power for over 24 hours?
Have you changed the fuse? If not, please replace the fuse in the plug with another
13 amp fuse
Is the brushbar not turning?
Switch the machine off and unplug from the wall socket
Remove the cover from the base of the machine to access the brushbars and belt
Is the belt broken?
Yes?
A replacement belt is required, go to 'Spares' tab above
No?
Remove the belt and turn both of the brushbars by hand
Either brushbar stiff to turn by hand?
Yes?
A replacement brushbar is required, go to 'Spares' tab above
Have you checked the suction from the motor?
Remove the dirty water tank and switch the machine on
Place your hand over the rectangular hole located on the machine, where the dirty
water tank fits
Suction strong?
Yes?
Go to 'Have you checked the nozzle?'
Have you checked the nozzle?
Debris from the carpet can build up in the front nozzle. To prevent this happening,
throughly vacuum the carpet before using the machine
Debris in nozzle?
Remove the dirty water tank and rinse the nozzle with warm water to clear any
debris that may be clogged
No improvement?
Have you checked the seal?
Remove the dirty water tank
Complete a visual check of the seal on the top of the dirty water tank
Are there any splits/tears on the seal?
Yes?
A replacement tank is required, go to 'Spares' tab above
