UTEPO USP201PV24 Quick Start Manual

of GB/T18802.21-2004/IEC61643-21:200. The device features multi-level protection、high capacity for through-flow、low limiting voltage、quick reaction time、less insertion loss. It adapts to overvoltage protection for security video signal and power, protecting the device from the damage of induced overvoltage, switching overvoltage and static discharge. It’s widely used in security monitoring system, environment monitoring system. Please check the following item before installation. If it's missing, please contact the dealer Surge Protector 1 set User Manual 1 set Installation Steps 1) Before inserting the protector into the system, please make sure the grounding grid reach the specification; 2) please make sure the connection is stable; 3) Please make sure the grounding cable of the surge protector is as short as possible. Installation Board Diagram Power and video Surge Protector Notice: 1) Please make sure the connection is correct, otherwise it will cause the damage of the surge protector. 2) Please make sure to check the plug if the consumption is increasing. you can re-connect it or replace the surge protector 3) Please don't unpack the component personally. Application Features Standard: GB/T18802.21-2004/IEC61643-21:2000; Protection: Baseband composite video signal(Bandwidth more than 10MHz)、12~24 AC DC power; Features: Multifunction multilevel overvoltage protection, large max discharge current, low limiting voltage, quick reacting time, low insertion loss; Grounding Mode: Extension Line to ground; Design: Clear Logo, recognizable, aluminum shell, delicate size, easy installation. 1 2 Video Input Video Output Power Input Power Output CCTV CAMERA Coaxial Cable Power Cable Coaxial Cable Power Cable Surge Protector Power Monitor Power LED Notice Please make sure the connection direction is correct. PE Grounding

3 4 Problem Examination Item Description Video Working voltage(Un) 12V Nominal discharge current(In) 3KA Maximum discharge current(Imax) 5KA Protection level(Up) ≤40V Rate 30Mbps Response time 1ns Insertion loss ≤0.5dB Connector BNC male Rated load current DC500mA Power Working voltage(Un) 24V Nominal discharge current(In) 5KA Maximum discharge current(Imax) 10KA Protection level (Up) 100V Response time 25ns Environmental Working temperature -40℃～85℃ Storage temperature -40℃～75℃ Humidity (non-condensing) 0~95% Mechanical Weight 100g Dimension (L×W×H) 100mm×60mm×38mm Outer shell Aluminum Inspect surge protector Using multimeter “Ω” measuring input and output wire line resistance is 0Ω;If ,resistance value is too much ,please replace for a new one. Using multimeter “ Ω ” measuring wire line resistance to ground wire(yellow green cable), over 400kΩ. If it resistance value is too low, such as 0Ω, please replace for a new one.