Toshiba NV Series Hardware Manual

6F8C1497 94 3.8 Mounting/Dismounting Terminal Block Signal Conversion Adapter This section describes the procedure to mount and dismount the terminal block signal conversion adapter of the T series migration system to and from base unit BUM7B. For mounting and dismounting modules such as G2 I/O or G3 I/O with terminal blocks and connectors, refer to “Unified controller nv series type1 light Controller Unit User’s Manual - Basic Hardware -” (6F8C1497) or “T3/T3H User’s Manual - Hardware - ” (UM-TS03***-J002). ■ Procedure to mount the terminal blo ...

6F8C1497 86 3.7 Mounting/Dismounting Modules Follow the precautions below when mounting or dismounting modules to and from base unit BUM7B for the T series migration system. For mounting and dismounting modules of type1 light controller or T3 series, refer to “Unified controller nv series type1 light Controller Unit User’s Manual - Basic Hardware -” (6F8C1497) or “T3/T3H User’s Manual - Hardware -” (UM-TS03***-J002). The modules including G2 I/O are secured on base unit BUM7B with the top and bottom lock levers and a screw at the top. Be sure to t ...

9 Table 1.6 Mounting slots on the expansion base unit Slot Base unit PIF PS S0 S1 S2 S3 S4 S5 S6 S7 S8 BU668 - - × IO IO IO IO IO IO IO IO BU666 - - IO IO IO IO IO IO BU664 - - IO IO IO IO PIF: For mounting the expansion interface module (IF661) PS: For mounting the power supply module (PS693, PS632, PS652) S0 - S8: For mounting modules I/O: For mounting the G2 I/O module ×: Not mountable. Be sure to install an empty module (SP600). Table 1.7 Mounting slots on the remote station main base unit Slot Base unit PIF ...

139 B The cables listed below are attached to the terminal block signal conversion adapter. Table B.2 Cables attached to the terminal block signal conversion adapter Model Product code Terminal conversion cable Connected to: Usage G3 I/O G2 I/O CBM31 HCBM31*CS Connector type DI334 DI634 Attached to EXM31 DO334 DO634 Attached to EXM32 PI312 PI632 Attached to EXM33 CBM34 HCBM34*CS Terminal block type AD368 AD668 Attached to EXM34 CBM35 HCBM35*CS Terminal block type DA364 DA664 Attached to EXM35 CBM36 HCBM36*CS Termin ...

39 2 Refer to the following manuals for the appearance and specification of I/O modules: ･Integrated controller model 200 series Sequence Controller S2 User’s Manual - Basic Hardware - (6F8C0836) S2T User’s Manual - Basic Hardware - (6F8C0936) S2E User’s Manual - Basic Hardware - (6F8C1094) ...

6F8C1497 72 Caution Mount the power supply module, the controller module, the station bus module, the I/O module , the interface module and the terminal block signal conversion adapter to the base unit Otherwise, it may cause electric shock, injury, or failure. Do not use them by themselves for other purposes. Caution Turn power off before installing and removing the modules, the base unit, the terminal blocks or the terminal block signal conversion adapter Otherwise, it may cause electric shock, malfunction, or failure. Caution Avoid foreign debris like wire ...