Toshiba NV Series Instruction Manual

6F8C1575 116 Where (100[V])2 10[kΩ ] × (2.5～3) ≒ 3 [W] P= In addition, you must make sure that when the bleeder resistor is selected as above, the output current at sensor ON time is within the tolerance. (3) If a log external wiring of AC input is routed, an induced current may flow from the charging wiring to the open-circuited wiring because of the capacity across the cable. In this case, input OFF may be unable to be read although the corresponding output is OFF. You should make provisions for this case generally by installing a bleeder ...

6F8C1575 44 3.3 Connecting the Intelligent I/O Figure 3-6 Connecting the intelligent I/O Junction terminal block Junction terminal block Dedicated cable Serial bus Bus 1 connector Serial bus Bus 2 connector Intelligent I/O Intelligent I/O ...

81 8.2 Periodic Inspections Check the items below periodically (once every six months). Check them also when the ambient conditions or environment change. WARNING During inspection, pay special attention to not touch the power when measuring the supply voltage at the power terminal of the module. Failure to observe it may cause an electric shock. WARNING Never attempt to remodel, repair, disassemble, or adjust the equipment, any module, or board. Failure to observe this may cause an electric shock. C ...

Unified Controller nv series type2 light Controller Unit Instruction Manual 11 (2) Controller duplex configuration Figure 1-5 Controller duplex configuration Table 1-8 Application of parts of the controller duplex configuration Name Model Application Base unit BUM22 Single/duplex chassis extended slot x 1 Rear mounted, Duplexed power support Power module PS693 100 - 240VAC (85 - 264V) power 5V-7A Controller module PUM21 nv series type2 light controller Serial bus interface module SBM21 SBIF adapter ＣＨ２ ＣＨ２ Primary Secondary ACK1 ACK2 SB- 1 SB- 2 ＳＢ� ...

6F8C1575 68 ■ Controller module check If the RUN LED of the controller module does not light up although POWER LED of the power module remains lit up, check the following: ERRのL EDが点滅または点灯して いるか コントローラモジュールのモード スイッチはRUNになっているか RUN LEDは点滅状態か ディップスイッチをONにして電源 を立ち上げたか 消灯 Y ES NO 消灯 点滅 電源を再投入しても点滅または点灯している場合は モジュールの故障です。コントローラモジュールを ...