Toro Groundsmaster 360 Series Installation Instructions

Registration Plate Kit Groundsmaster® 360 Series Multi-Purpose Machine Model No. 120-6678 Installation Instructions Note: The Groundsmaster 360 Series Multi-Purpose Machine must be equipped with the Light Kit, Model 30512 or 30516 to operate the Registration Plate Kit Light. 1. Position the machine on a level surface, stop the engine, remove the ignition key and engage the parking brake. CAUTION If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure you or other bystanders. Remove the key from the ignition switch before you do any maintenance. Figure 1 1. Registration plate bracket 6. Flange head nut, 5/16 inch 2. Screws, #10 x 5/8 inch 7. Tree bracket 3. Plate light 8. Plastic tree plug (shown removed for clarity) 4. Flange head screw, 5/16 x .613 inch 9. Wire harness 5. Lock nut, #10 10. Drill a 13 mm diameter hole here 2. Centering the registration plate bracket on the rear of the hood, use it as a template to locate, mark and drill (2) 9 mm diameter holes through the hood (Figure 1). 3. At the approximate location shown in Figure 1, mark and drill a 13 mm diameter hole through the interior wall of the hood, near the seal bracket. 4. Route the bullet connector end of the wire harness through the drilled hole. © 2011—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN) Printed in the USA. All Rights Reserved

(Figure 1). 6. Route the wire harness along the top left side of the hood while plugging the tree brackets onto the hoods existing plastic tree plugs (Figure 1). 7. Drill a 13 mm hole in the hood screen to allow the connector of the registration plate light wire harness to pass through to the light. The hole in the hood screen should be aligned with the wire access hole in the rear plate assembly after it is mounted. 8. Mount the rear plate assembly to the rear of the hood with (2) 5/16 x .613 inch flange head screws and 5/16 flange head nuts (Figure 1). 9. Route the harness through the hole in the hood screen and the rear plate assembly (Figure 1). 10. Plug the wire harness connector into the rear plate lamp (Figure 1). 11. Mount the plate light to the registration plate bracket with (2) #10 x 5/8 inch screws and #10 lock nuts (Figure 1). Do not over tighten. Make sure the lens points downward and the wires are inserted through the hole in the plate mount. 12. Connect the registration plate light wire harness to the existing light kit harness. Important: Make sure the wire harness is clear of all hot, sharp or moving components. 13. Check the operation of the registration plate light. The plate light should illuminate when the lights are turned ON and the key is in the RUN position. 2