Thecus N3200 Manual 

1/3 01/Jul/2008 N3200 simple diagnosis flowchart 1. Purpose: to provide end users and customers a simple and quick procedure to identify which part failed in N3200. 2. Procedure 2-0. Don’t insert any HDDs into the N3200 system. Attach the power cord and then reset the IP address and admin password to the default settings. a) Power on the N3200 and immediately press the Reset button for 30 seconds. b) This resets the N3200 to its default IP address and password settings. Default IP: 192.168.1.100 Default admin password: admin 2-1. Without insert any HDD into the N3200 system, attach the power cord and connect the LAN cable between N3200 WAN port and a PC or NB. Don’t use a HUB. 2-2. Turn on the N3200 system and check the front panel LCD message. The LCD should showing BOOTING after power button pressed, about 50~60 seconds later with a beeping for system booting successfully. If without this beeping sounds, the firmware may be corrupted during improper firmware upgrade procedures. It means the motherboard doesn’t work any more and need to be repaired. 2-3. Set the IP address of a PC or NB as 192.168.1.111, and then access the login webpage. Make sure the N3200 and the PC or NB is directly connected through a LAN cable, not through a HUB or a router. 2-4. Check if the Admin login webpage shows up and works fine. Then check if the system status is normal and insert a HDD to verify HDD LED works fine. In case the results are positive, it means the N3200 system is OK. Otherwise, the N3200 is damaged. 2-4-1. Since press the reset button during booting process, and N3200’s WAN IP address will be set to 192.168.1.100 temporarily. At this time all the file services will be stopped. When you point your browser to 192.168.1.100, you will see the following screen.

2/3 01/Jul/2008 N3200 simple diagnosis flowchart Please select “Reset to Factory Default” option and press the apply button, the system will be reset. When select “Reset to Factory Default” option, the system will be reset. Below are the default system settings: Admin password → admin LAN 1 IP address → 192.168.1.100 LAN 1 IP Gateway → 192.168.1.1 LAN 1 Jumbo Frame Support → Off LAN 2 IP → 192.168.2.254 LAN 2 Jumbo Frame Support → Off HTTP Port → 80 HTTPS port → 443 2-5. Suppose the N3200 is bad. If the power LCD message doesn’t showing IP address and both system and power fans work fine after power button pressed, the motherboard needs to be checked and repaired. Otherwise, the power supply unit has problems.

3/3 01/Jul/2008 N3200 simple diagnosis flowchart N3200 30 N3200 5. LCD showing IP address, Power LED glows blue, and system fan works? 1. Attach the power cord and connect LAN cable to N3200 WAN port