Team Electronic MiCo 446 Operating Instruction

3 / 16 Setting Up 17 - 18 Operation 19 - 24 Notice : • Conformity 24 • Approval 24 • Servicing 25 • General Precautions 25 Connection Speaker/ 26 Microphone Technical Data 27 English Contents Operating Instruction 2 ...

Connectors 2 1 3 4 5 6 7 8 9 10 11 12 13 External Speaker Jack [SPK] External Microphone Jack [MIC] Push to Talk Key [ PTT ] Display Screen Function Key /Key Lock [F] CTCSS Code Key / Call Tone Key [C] Monitor Key / Display Backlight [❋] Red On/Off Power Switch Speaker / Microphone Selector Key [▲] Selector Key [▼] Antenn ...

Insert 3 Alkali batteries (AA size). Make sure that the polarity is correct as indicat- ed inside the battery compartment. You may also use 3 x 1.2 V standard rechargeable NiCd or MiMH batteries. For long time operation it is adviseable to use the extra battery pack APP-446-M. The MiCo 446 is ready for use after the batteries ...

be obtained only by using fresh or fully charged batteries. Remove the batteries out of the set if it is not intended to be used for longer period. Rechargeable batteries or the rechargeable battery pack APP-446M can be recharged inside the transceiver by using the suitable desk drop in charger SLG-446-M. Batter ...

1. Red On / Off Switch Press and hold red button (8) to turn on. Symbols appears at the display. Press and hold again same button to turn off. 2. Display (4) (1) Displays current channel 1-8, (2) Displays current CTCSS code 1-38 OFF mode when no figure is shown (3) Displays Transmitting Signal Strength (4) Displays ...

To transmit depress and hold the PTT key (3) at left side of the set. The sensitivity of the built-in microphone has been set to give good results speaking normally at a distance of 5-10 cm. 4. Selector Keys [▲▼] The desired volume level can be adjusted by pressing one of the selector keys [▲▼]. The volume level will ...

Press F key 1 time to activate the chan- nel setting mode. Press on of the selector keys [▲ ▼] momentarily to select the channel number 1-8. 8. Tone Call Selection Press the F key 2 times to activate the tone call setting mode. Press one of the selector keys [▲ ▼] to choose beep tone C1-C7. How to operate : Press an ...

while VOX is set “ON” and immediate press of F key can attain this mode. Press selecor key [▲] or [▼] to set the sensitiv- ity level. The highest level L4 makes the VOX most sensitive. 11. Remote Monitor To attain remote monitor function, CTCSS code must be set in advance. Press the F key s ...