Takstar CM-60 Manual 

等效噪声级：≤20dB A 最大声压级：130dB (T.H.D≤1% at 1KHz) 输出阻抗:100Ω±30% (at 1KHz) 低频衰减：100Hz 12dB/倍频 使用电压：48V幻像电源 连接线的安装与拆卸 1.把卡侬（XLR）插头插入麦克风，旋转插头使上面的扣键与 麦克风上的槽口对准，然后将插头推入麦克风，直至扣键定 位。 2.麦克风与连接线分开时，可握住插头，同时按压扣键，然后 将插头从麦克风拉出。 LOW CUT 使用说明 连接幻像电源 开关的使用 低频衰减：当开关处于“ ”位置时，为无衰 减状态，当开关处“ ”位置时，可均衡近距 离拾音时的低频提升效应和降低噪声、舞台地 板振动声等。 ※在使用低频衰减开关进行调节时，请关掉扩音器、嗽叭或将 音量调小，以避免开关产生的冲击声影响喇叭。 1. 使用时，应先将扩音器或调音台音量控制调小，然后将幻 像电源与麦克风连接好，再打开幻像电源的电源开关，并 将音量从小到大慢慢调节至合适，以免喇叭受到冲击。 2. 用手罩住麦克风头部，或使麦克风接近扬声器，可能产生 啸叫声，遇此情形时，首先降低音量，拉开同麦克风的距 离，尽量使麦克风不同扬声器相对。 3. 麦克风灵敏度高，必须注意不要从高处落下或给予强烈 冲击。 4. 麦克风不使用时应存放在干燥清洁的地方，避免在温度、 湿度过高的场所保管或使用，以免影响灵敏度和音色。 ※ 本产品相关规格及参数如有变更，恕不另行通知。 ※ 如需服务和配件方面的信息，请就近和得胜代理商联 系，或请访问得胜网站www.takstar.com -30 -40 -50 -60 -70 (dBV/Pa) 20 2K 20K 50 100 200 500 1K 5K (Hz) Frequency Response Graph Uni (at 1kHz) -directional 0° 30° 60° 90° 120° 150° 330° 300° 270° 240° 210° 180° 国内销售部 服务热线：400 6828 333 传真：0752-6383950 地址：广东省惠州市博罗县龙溪镇富康一路2号 邮编：516121 网址：www.takstar.com

Polar Pattern: Uni-directional Frequency Response: 30Hz~18kHz Sensitivity: -38dB±3dB (0dB=1V/Pa at 1kHz) Equivalent Noise Level: ≤20dB A Max .Input SPL: 130dB (T.H.D≤ 1% at 1kHz) Output Impedance: 100Ω±30% (at 1kHz) Bass Filter: 100Hz 12dB/octave Power Requirements: 48V DC Phantom Powerr Specifications: Frequency Response Graph: 1. Insert the XLR connector into the microphone. If necessary, rotate the connector to align the key on the connector and the groove in the microphone. Push the connector into the microphone until it clicks. 2. To disconnect the cable and microphone, grasp the connector while depressing the tab. Pull the connector away from the microphone. Connecting and disconnecting the microphone cable: Operations: How To Use Switch: Usage: TAKSTAR CM-60 microphone, which adopts the Pressure Gradient Transducer cartridge with vapor-deposited gold diaphragm and is a professional condenser the cardioids polar pickup pattern. These feature the microphone with the characteristic of high sensit ivity, wide frequency response, small distortion, as well as low self-noise. And its clear and natural sound quality together with its effective function of reducing the feedback sound make it rightly suitable for orchestral musical instruments use. CM-60 applications such as broadcasting, recording, and show on stage, ect. may be used with confidence in a wide variety of professional -30 -40 -50 -60 -70 (dBV/Pa) 20 2K 20K 50 100 200 500 1K 5K (Hz) Frequency Response Graph Uni (at 1kHz) -directional 0° 30° 60° 90° 120° 150° 330° 300° 270° 240° 210° 180° XLRF XLRM XLRF PHANTOM POWER SUPPLIER VOICE AMPLIFIER, MIXER, POWER AMPLIFIER LOW CUT Low frequency attenuation: when the switch is on the position “ - ”. It is of no attenuation, when it is on “ ” position, it can balance the low frequency raising effect of short distance pickup and reduce feedback, not easy tocause howling. ※ Please turn off or just turn down the voice amplifier and speaker while you adjusting the low frequency attenuation, in order to prevent the speaker from pounding. 1. Turn on your amplifier or mixing board and set the volume control to minimum position, To connect the phantom power to the microphone turning on the phantom switch, accommodate the volume control from low to high so obtained effect to your moderate level for protected the sauna from pounding. 2. If the head of the microphone is covered by hand or brought close to the speaker, a howling sound may be generated. To prevent this, first decrease the volume, then place the microphone so that it is not pointed to the speaker and that there is a sufficient distance between the microphone and speaker. 3. The sensitivity of cartridge is very fine, don’t do drop. Hit it or apply strong shock to it. 4. To maintain the sensitivity and quality of sound reproducing, avoid exposing it to moisture and extreme temperatures. ※ Specifications are subject to change without prior notice ※ For additional information about service or parts, please contact your local authorized Takstar Service Center or visit Takstar at www.takstar.com International Sales Department Address: No.2 Fu Kang Yi Rd., Longxi Boluo Huizhou, Guangdong 516121 China Website: www.takstar.com Tel: +86 752 6383951 Fax: +86 752 6383950 E-mail: [email protected]