Sidekick Foot Pegs Quick Start Manual

The Sidekick Foot Pegs are convenient footrests for a rear-seated passenger on the Tern GSD. Safety Carrying Passengers Passenger should NEVER stand, mount or dismount by stepping on the Foot Pegs. It may be illegal to carry passengers on a bike in your area even if it has been designed or configured to do so. Check your local regulations before carrying passengers. Seat Pad We strongly suggest that the Foot Pegs be used in conjunction with the Sidekick Seat Pad. Handholds Whenever the GSD is in motion, the passenger must hold on to something stationary such as Sidekick Bars, frame, saddle or add-on handle. Helmet Passengers must wear an approved helmet. Attire Avoid wearing loose-fitting clothing such as skirts, pants, and shoelaces which can get caught in the spinning wheel. Take care that all straps are tied down. Protection from Tire Foot Pegs and Seat Pad must be used with a set of flat folding Tern Cargo Hold™ Panniers, Sidekick Wheel Guards, or pannier bags to act as a safe- guard from the tire. • Foot Peg x 2 • M6 Screw x 2 • M6 Washer x 2 Foot Peg for left-hand side is marked with an “L” and right-hand side is marked with an “R”. What’s included Use Proper Equipment 4 1 2 3 Carrying rear passenger(s) require the GSD to be equipped with (1) proper seating, (2) a pair of foot supports, (3) handholds and (4) foot and leg protection on both sides of the bike.

This Product comes with an ONE (1) YEAR Limited Warranty from the date of retail purchase by the original end-user. If a material or workmanship defect arises and a valid claim is received within the Warranty Period, this Product will be replaced. Mobility Holdings cannot be held liable for damages to personal property due to misuse or improper care and maintenance. This Product Warranty does not, under any circumstance, cover the replacement or cost of any third party product used with or connected to the Product. Tern, the Tern Werd (logotype), the Tern Berd (device), GSD, Sidekick Foot Pegs, used alone or in combination are trade names, trade devices or registered trademarks of Mobility Holdings, Ltd. © 2019 Mobility Holdings, Ltd. ternbicycles.com To unfold, gently push Foot Peg inward toward wheel to release spring. Foot Peg will unfold upon release. To fold, push Foot Peg toward wheel until it clicks. Do not push past this point or Foot Peg will unfold upon release. Keep Foot Pegs folded when not in use. Unfolding Folding Installation Tools required (not included) • 5 mm Allen Wrench Stand GSD in the vertical position for easier access to the Foot Peg brackets. Push Foot Pegs firmly into bracket until screw and bracket holes are aligned. Insert the screws and washers, as shown above. Tighten to a torque of 6 – 7 Nm. If the screws are too tight, the spring release mechanism will not work properly. If you are unsure of how to install this product, please consult a qualified bicycle technician.