Pollard 313 Assembly Instructions

Stool With Backrest Assembly Instructions www.pollardbros.com 1 Lay seat on a hard surface with under side up. Turn stool frame upside down and line up holes in frame with holes in seatsupports fasten with (4) ¼” - 20 x 5⁄8” Hex Head Machine Screws, ¼” Lock Washer, and ¼” Hex nut. 2 • (1) Steel Stool Seat • (1) Stool Frame • (1)Steel Back Rest • (2) Back Braces • (4) Leg Extensions • (4) Leveler Glides Includes: Steps: ¼” Hex Nut ¼” Lock Washer 20 x 16 x x 8 x 4 ¼” x 5⁄8” Round Head Machine Screw ¼” x ¾” Hex Head Machine Screw x 4 Tools Needed: wrench fat head screwdriver ¼” -20 x 5⁄8” Hex Head Machine Screw 4 x ¼” Hex Cap x 4 1/4” x 5⁄8” Carriage Bolt

. . . . phone(773)763-6868 fax(773)763-4466 toll free(800) 551-5566 After all brackets are in place, make sure stool is square and then, tighten all screws. [2] 3 Turn Stool upright. Attach steel stool back to back braces by inserting (4) ¼” x ¾” Carriage Bolts through steel back and stool back brace, and fasten with (4) ¼” Lock Washers, and (4) ¼” Hex Caps. HAND TIGHTEN ONLY. Attach Back Braces with Back Rest to Stool Frame using (4) ¼” x ¾” Hex Head Machine Screws, ¼” Lock Washers, and ¼” Hex Nuts. HAND TIGHTEN ONLY. 4 5 6 Square up Back Rest to Frame if needed. Tighten Carriage Bolts in Steel Back Rest. The Bolt will ft into the square holes of the back. Determine the desired height and bolt on the four adjustable extension legs using (8) ¼” x 5⁄8” Round Head Machine Screws. ¼” Split Lock Washers and ¼” Hex Nuts. Tighten and Turn Stool Upright. Note: If glides were purchased, you should install them now.