Oki ES9465 Procedure For The Installation

RADF Paper Feed Maintenance Kit ES9465/ES9475 MFP Step 1 Unit Disassembly, Part Replacement Step 2 PM Counter Reset PN: 45735719 DF-KIT-3018 KIT: PERIODICAL MAINTENANCE DF-KIT-3018 Pick up roller ASYS-ROL-FEED 1 Feed roller ASYS-ROL-FEED 1 Separation roller ASYS-ROL-RET 1

1 Open the jam access cover. Remove 2 screws and take off the bracket. 4 3 2 Remove 1 clip and slide 2 bushings. Be careful not to drop the pin because it will come off when the shaft is pulled out. 5 Remove 4 screws and take off the bypass upper guide. Take off the paper feeder unit. Remove 1 clip and pull out the shaft. Take off the pickup roller and replace it. 6 7 Remove the clip, pull out the shaft and take off the feed roller. Replace the roller. Remove 2 screws. Slide the feeder upper Make sure you assemble the pickup roller with the one-way clutch in the correct direction. Remove 2 screws and take off the separation roller holder and separation roller unit. Remove 1 bushing and clip, and then take off the separation roller. PM Part PM Part Make sure you assemble the feed roller with the one-way clutch in the correct direction. 9 8 PM Part

(1)Enter PM Support Mode Enter Service Mode [6]+[START]+[POWER]ON (2)Authentication screen If a service password has been registered enter the service password and select “OK”. If a service password has NOT been registered leave password blank and select “OK”. (3)Use the page down to go to page 3 of 4. Highlight “RADF” and select “RESET”.

This function resets: • Pick up Roller • Feed Roller • Separation Roller