RS N 8000 Series System Manual

E-1 Verification of the calibration Calibration of the power indication was successful if the values displayed in the Calibration window area for Gain and Offset are not equal to zero. Reflected power display Note To allow calibration, the transmitter must be operated at the required transmitter power. 1. Select NetCCU > RF Probe Antenna > RF Probe Reflected. The RF Probe Reflected window opens. 2. Use Set Gain to measure and save the DC voltage of the reflected-power test point at nominal output power. Note To abort, exit the Trigger: Set info win ...

2098.0188.72 - 2.20 - E-1 Fig. 24 Absorber The absorber resistors (dummy loads) for the combiner are located on the absorber block. When the combiner is being operated in unbalanced mode (e.g. with one or more amplifiers disabled or removed) the non-combinable component of the RF power is expelled as addi- tional heat energy via the transmitter exhaust duct. ...

E-1 1 Equipment Supplied 1.1 Integrated Transmitter Components In the case of transmitters in the R&S NV8300E/V family, the following units and modules are already installed in the rack (depending on the equipment supplied): Note Use the tables below to check that all the relevant components have been supplied. Quantity Part name Type ID 1 Cabinet rack R&S KG830M1 2096.2002.02 1 Mid-range power distribution 2096.3344.XX 1 R&S NetCCU800 R&S NetCCU800 2095.8007.02 1 - 2 TV exciter SX800 Transmitter type: NV830xE NV830xV R&S SV800 Quantity of R&S SV800 ...

1171.0000.42-05.00 Page 10 12. Si un producto se instala en un lugar fijo, se deberá primero conectar el conductor de protección fijo con el conductor de protección del producto antes de hacer cualquier otra conexión. La instalación y la conexión deberán ser efectuadas por un electricista especializado. 13. En el caso de dispositivos fijos que no estén provistos de fusibles, interruptor automático ni otros mecanismos de seguridad similares, el circuito de alimentación debe estar protegido de modo que todas las personas que puedan acceder al prod ...