Rowlinson Clarendon Assembly Instructions Manual
Text of the manual
• Power drill/screwdriver
• Cross head drill bit
• 3mm diameter drill bit
•12mm diameter drill bit
• Hammer
• Sharp knife
• Spirit level
• Silicon sealant
• Step ladder
1
2
3
11
6
8
5
4
7
25
10
9
12
13
14
15
16
17
18
19
20
22
21
23
24
29
26
1. Floor section
Prepare a level area for the Summerhouse to sit. Lay the three floor panels upside down and secure them together using 5 x 50mm screws per join.
Important note
To “VALIDATE” the guarantee, adequate provision must be made to ensure ground contact is avoided and air is able to circulate underneath the building.
Placing the buildi
Panel frames rest on floor.
Panel cladding overhangs floor edge.
Front panels
Use this diagram to check
the correct orientation of the
corners
Important
It is recommended to drill pilot holes
with a 3mm drill bit for each screws in
this section.
3mm
Drill
5. Wall panels
Position two large panels on
8. Securing the walls to the floor
Ensure the walls are sitting square on the floor. Secure each panel down using 2 x 63mm screws per panel, screwing through the panel framing and floor into the floor joists.
Back panel
Side panel
Panel frame
Floor joists
Floor
6. Header panel
Join together the two halves of the header panels using 2 x 50mm screws. Place the
Cross section of wall
Overhead view
roof centre block
11. Roof centre block
Position the roof centre block in the hole in the middle, ensure it is flush with the roof panel framing and secure in place using 4 x 50mm screws. Screw through the frames
of the rectangular roof panels into the centre block. Drill four holes in the inside roof cover, centre the cov
