RIOTEC LS6300J Programming Quick Manual
Text of the manual
Programming Quick Guide
-LS6300J
Installation
Make sure that the scanner has the correct cable to plug into PC as below
described,
After you plug cable into PC and hear the beep sound, the scanner can read
the barcodes now.
Reset Configuration to Default :
If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan A1 for USB HID or B1~B2 for RS232 or
USB Serial. This will reset the scanner to its factory defaults.
USB HID
RS232/ USB serial
A1
B1
B2
*Note : Please install PL-2303 driver for USB serial
Keyboard Country (FOR USB HID Only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States: @ | $ # { } [ ] = / ‘ \ < > ~
USA
(Original setting)
France
Italy
Spanish
Portuguese (Brazil)
Portuguese (Portugal)
1D Symbologies – 1
ENABLE
CODABAR
DISABLE
ENABLE
CODE 39
DISABLE
ENABLE
Interleaved 25
DISABLE
ENABLE
Industrial 25
DISABLE
1D Symbologies – 2
ENABLE
Matrix 25
DISABLE
ENABLE
CODE 93
DISABLE
ENABLE
CODE 128
DISABLE
ENABLE
GS1-128
DISABLE
ENABLE
UPC-A
DISABLE
ENABLE
UPC-E
DISABLE
ENABLE
EAN 8
DISABLE
ENABLE
EAN 13
DISABLE
ENABLE
ISBN
DISABLE
1D Symbologies – 3
ENABLE
ISSN
DISABLE
ENABLE
GS1 DataBar
DISABLE
ENABLE
GS1 Databar
Limited
DISABLE
ENABLE
GS1 Databar
Expanded
DISABLE
2D Symbologies
ENABLE
PDF 417
DISABLE
ENABLE
QR Code
DISABLE
ENABLE
Micro QR Code
DISABLE
ENABLE
Data Matrix
DISABLE
ENABLE
Aztec Code
DISABLE
Information in this document is subject to change without notice.
For more information, please visit:
www.riotec.com.tw
R_181023_01
