Servend MD 150 Replacement Manual

Foodservice Group MD-150, MD-200, and MD-250 Duratran/Medallion Replacement FIGURE 1 Knurl Screws Tools Required z 6 in 1 screw driver 1 1. Disconnect power to the dispenser. 2. Remove full lid or manual fill lid from unit. 3. Remove the 2 Knurl screws from top of merchandiser. (See Figure 1) 4. Remove the merchandiser from the unit. (See Figure 2) 5. Remove the seven screws from around the outer top and bottom edges of the merchandiser. (See Figures 3&4) (The screws are threaded into rubber bumpers inside the merchandiser. This will free the medallion for removal) (See Figure 5) 6. Remove the existing medallion from the merchandiser. (See Figure 6) FIGURE 2 FIGURE 3 3 Bumber Screws on top of merchandiser

Foodservice Group MD-150, MD-200, and MD-250 Duratran/Medallion Replacement FIGURE 6 7. Place the new medallion into the merchandiser. (Be sure the medallion is right side up.) 8. Replace the seven outer screws and bumpers into the merchandiser (Screws go on the outside of the merchan- diser and bumpers go inside of the merchandiser. The bumpers are what the screws thread into.) 9. Replace the merchandiser in reverse order. 10. Re-install lid. 11. Reconnect power to the dispenser. FIGURE 4 4 Bumper Screws on bottom of merchandiser FIGURE 5 Rubber Bumpers