injen technology SP1381 Quick Start Manual
Text of the manual
2- 2 3/4” x 3” step hose (#3040)
2- 2 3/4” straight hose (#3043)
6- Power-bands (.312)(.040)
(#4003)
2- Power-bands (.362)(.048)
(#4004)
1- 6mm vibra-mount
Remove the battery cables from the battery post and
remove the battery the from the engine compartment.
Disconnect air box cleaner from the air intake duct
and lift the air box out of the engine compartment.
Depress end clips on the electrical harness clip and
pull the clip away from the mass air flow sensor.
Press the step hose over the throttle body and u
The plastic plug is removed from the upper tab, then
the resonator is gently pulled out of the resonator
opening.
The vibra-mount is screwed into the pre-tapped brace
on the engine mount.
Screw the vibra-mount into the brace until it sits flush
over the engine mount.
The driver side bumper is pulled away and the res-
onator box is removed from the inside cor
Insert directional mass air flow sensor over the
primary intake until they both have butted up against
each other.
The intake is aligned to the vibra-mount stud located
on the engine mount.
Peel the driver side bumper back and insert the top
section of the third intake into the resonator opening
as shown above.
The intake is inserted into the resonator open
,9 W7:+#(:176',*:+#:A#,)'#*+/,-66-,*:+I#8'(:++'(,#,)'#+'B-,*;'#<-,,'80#,'81*+-6#<'A:8'#0:>#/,-8,#,)'#'+B*+'=##
/9 46*B+#,)'#'+,*8'#*+,-.'#/0/,'1#A:8#,)'#<'/,#7://*<6'#A*,=##L+('#,)'#*+,-.'#)-/#<''+#78:7'860#A*,,'9#(:+,*+>'
,:#,*B),'+#-66#+>,/I#<:6,/#-+9#(6-17/=
-9 @'8*:9*(-660I#8'()'(.#,)'#-6*B+1'+,#:A#,)'#*+,-.'#/0/,'1#-+9#1-.'#/>8'#,)'8'#*/#78:7'8#(6'-8-+(
