L.L.Bean ADIRONDACK Manual 

Thank you for purchasing this Upright Adirondack Chair. Assembly of this product requires a 7/16" wrench or adjustable wrench. Having someone assist you by holding parts in place during installation will make the process easier. 4522 0NPT7 all-guide s.com

We have found this to be of great value when first assembling this product. STEP 2 Remove all parts and hardware from packing material. Wooden pieces should be placed on a non-abrasive surface (like the carton or carpet) to prevent damage to the finish. STEP 3 Identify all parts using diagram at right (A) Back Assembly (B) Back Legs (C) Right Arm (D) Left Arm (E) Seat Assembly (F) Front Leg Assembly STEP 4 Identify and count hardware using diagram at right. Assembly of this product requires a 7/16" wrench (or adjustable wrench). Having someone assist you by holding parts in place during installation will make the process easier. NOTE: Make sure all parts are correctly lined up before tightening. STEP 5 Stand Seat Assembly (E) up on edge as pictured on right. Insert joint connector through bottom predrilled hole of back leg (B) as shown on right, then through the bottom predrilled hole on the back of the Seat Assembly. Do not fully tighten. Repeat for the other back leg (B).

Seat Assembly (E) up and place front of Seat Assembly (E) into Front Leg Assembly (F). Insert four joint connectors through the predrilled holes of Front Leg Assembly (F). The joint connector will go through the predrilled holes in the front of the Seat Assembly (E). Secure with a washer and lock nut as shown on right. STEP 7 To attach arms (C, D) insert two joint connectors through the predrilled holes on the inside of the Front and Back Legs (F, B), then through the predrilled holes in the arm cleats and secure with washers and lock nuts. Do not fully tighten. STEP 8 Attach Back Assembly (A) to Back Legs (B) by inserting two 2-1/2” Lag Bolts with washers through the top holes in Back Legs (B), then tighten into the Bottom Cleat of the Back Assembly (A). Fully tighten.

washers through the predrilled holes in the back arm cleats (C, D), then into the predrilled holes of the middle back cleat of Back Assembly (A). **Tighten all lock nuts and screws securely on chair. CARE Thank you for choosing our classic L.L.Bean Adirondack furniture. The natural finished furniture is made of solid oak and finished with a wood preservative. This oak hardwood will gray slightly as it ages. Painted furniture is made of maple hardwood and finished with a rugged weather-resistant acrylic paint. All of our Adirondack Furniture is made in the United States. Recommendations for extending the life of your furniture: • During inclement weather and off-season, bring furniture indoors or use a furniture cover. • Over time, wood exposed to the ground will absorb moisture, which may cause rot. If you use this chair on a lawn, occasionally move it to a dry surface (patio or deck) to allow the legs to dry out. • A deck, porch, or patio is the best location for your furniture. • To clean, wipe accumulated dirt with a solution of warn soapy water and a soft cloth; rinse thoroughly with clean water. Over time your Adirondack furniture will need refinishing. We recommend the following: • Lightly sand each piece with a fine grade of sandpaper before applying paint or finish. You do not have to sand down to bare wood. • On painted furniture apply a primer first. Finish with an outdoor weather resistant acrylic paint. The original paint color can be matched at your local hardware or paint store. • If you have solid oak furniture, sand and finish with any high-grade wood preservative. www.llbean.com Product Support 1 800 341 4341