Magene T100 Quick Start Manual
Text of the manual
Quick Start Guide
Unboxing
T100 Power Trainer
Quick release lever
Email: [email protected]
Website:https://magenefitness.com
After-sales service:[email protected]
Quick Release Dropout Converteree
Cassette Converter Washer
NOTE：
1.T100 Power Trainer is as shown on the left.The user needs to
prepare any parts not included in the packaging.
2.Two Triple-A battery are needed for T100 Power Trainer,please
purchase and install them follow the steps of 7.2
3.A axle (sold separately) is required to mount a bike with drum
shaft components.
Thank you for purchasing the T100 Power Trainer.
Please read the instructions carefully before using the product. Feel free to contact us
if you have any questions or concerns:
Remove the T100 Power Trainer and all accessories from the box and be sure to keep
the original box for subsequent transportation and storage. In case of warranty repairs
and returns, be sure to use the original packaging.Otherwise the Company will not
bear any responsibility for any loss caused during transportation.If the packing box
and foam are missing, please contact the local dealer or service personnel.
Please follow the instructions to use the product.
1. Place the T100 Power Trainer on a flat and stable surface and ensure that there are
no obstacles or dangerous objects near the product.
2. Pull the movable legs to the maximum extent and make sure that the product sits
firmly without wobble.
3. Install batteries or rotate the pulley to activate the trainer, at which time the LED
indicator will flash slowly.
The description of any accessories (such as flywheels, axle.) below is only for the
purpose of explaining how to use the product as only those included in the packing
list come with the product.
Longer end on the inside
for 130mm dropouts
Shorter end on the inside
for 135mm dropouts
Longer end on the inside
for 142mm dropouts
Shorter end on the inside
for 148mm dropouts
Quick release installation
Fig 2
The axle set is for sold separately.
Note
Installation direction
Installation direction
Axle installation
Fig 3
4
4. The T100 Power Trainer is compatible with cassette flywheels produced by Shimano
and SRAM,including 11-speed flywheels (direct installation) and 8 9 10-speed flywheels
(requiring flywheel baskets).Campagnolo transmission users can also install a Shimano
cassette flywheel on the trainer.
Please use dedicated installation tools when installing flywheels.
Installation of the bicycle
Freehub washer
Freehub washer
Installation
operation
Installation
operation
Quick release installation operation
Alxe installation operation
Installation of the bicycle
5
1. Fit the bike chain to the smallest front and rear
flywheel and remove the rear wheel of the bike.
2. To install a bike on the product, first align the
bike chain with the smallest flywheel on the T100
Power Trainer, then press it until the fork end is
fully fixed on the product's axle.
3. Push the quick release lever to the OPEN
position and push the product firmly against
the inside of the bike's bottom.
4. Use your left hand to slowly tighten the
adjustment nut clockwise while using your right
Fig 5
Fig 6
Fig 4
