Mitsubishi Electric MELSERVO-JET MR-JET-G-N1 Series Operation & User’s Manual

6.3 Symbol for the new EU Battery Directive 49 6 6.3 Symbol for the new EU Battery Directive The symbol for the new EU Battery Directive (2006/66/EC) that is plastered to the general-purpose AC servo battery is explained here. • This mark is valid only in EU. This mark is in accordance with directive 2006/66/EC Article 20 "Information for end-users" and Annex . MITSUBISHI ELECTRIC products are designed and manufactured with high quality materials and components which can be recycled and/or reused. This symbol means that batteries and accumulators, at ...

Please dispose of this product, battery (primary battery), and other options according to your local laws and regulations. ABOUT THE MANUAL e-Manuals are Mitsubishi Electric FA electronic book manuals that can be browsed with a dedicated tool. e-Manuals enable the following: • Searching for desired information in multiple manuals at the same time (manual cross searching) • Jumping from a link in a manual to another manual for reference • Browsing for hardware specifications by scrolling over the components shown in product illustrations • Bookmarking frequently ...

7.1 Extension setting servo parameters group ([Pr. PC_ _ ]) 55 7 [Pr. PC73_Speed reached 2 - Output filtering time (SA2F)] This servo parameter sets the time until the speed reached 2 output turns on. If the state where the error between the speed command and the servo motor speed is within [Pr. PC72 Speed reached 2 - Output range] continues for the setting value of this servo parameter or longer, bit 10 (Target velocity reached) of [Statusword (Obj. 6041h)] turns on. This function is enabled in the profile velocity mode. This servo parameter corresponds to [Velocity windo ...

Motor-less operation The motor-less operation cannot be used in the linear servo motor control mode. Without connecting a servo motor to the servo amplifier, output signals or status displays can be provided in response to the controller commands as if the servo motor is actually running. This operation can be used to check the sequence of a controller. Use this operation after the forced stop has been released. Use this operation with the servo amplifier connected to the controller. To perform the motor-less operation, set [Pr. PC05.0 Motor-less operation sel ...