Metra Electronics MPS-GEN01 Installation Instructions

MetraOnline.com © COPYRIGHT 2020 METRA ELECTRONICS CORPORATION REV. 2/12/20 INSTMPS-GEN01 INSTALL ATION INSTRUCTIONS MPS-GEN01 Attention! Let the vehicle sit with the key out of the ignition for a few minutes before removing the factory radio. When testing the aftermarket equipment, ensure that all factory equipment is connected before cycling the key to ignition. KIT FEATURES • ISO DDIN radio provision • Replaces upper pocket • Textured to match factory finish KIT COMPONENTS • A) Radio housing • B) Radio brackets • C) Phillips screws (12) TOOLS REQUIRED • Panel removal tool • Phillips screwdriver • 1/8” drill bit TABLE OF CONTENTS Dash Disassembly...................................................2 Kit Preparation........................................................2 Kit Assembly...........................................................3 A B C Polaris General 2016-Up Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle specific applications

upper dashboard. (Figure A) Continue to Kit Preparation (Figure A) (Figure A) 1. Enlarge the storage pocket opening to allow room for the aftermarket radio and mounting kit. (Figure A) Continue to Kit Assembly Remove shaded area

3 KIT ASSEMBLY 1. Secure the radio brackets to the radio housing using (4) Phillips screws provided. (Figure A) 2. Slide the radio into the radio housing assembly, then secure using screws supplied with the radio. (Figure B) 3. Complete all necessary connections to the radio, then test the radio for proper operation. Use Metra part number 44- UA20 (sold separately) for an antenna. 4. Slide the radio assembly into the dash. Pre-drill (8) pilot holes in the dash using a 1/8” drill bit. Using a manual screwdriver, secure the radio assembly to the dash using (8) Phillips screws provided. Do not overtighten! (Figure C) (Figure A) (Figure C) (Figure B)

Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow. ® Metra recommends MECP certified technicians Metra. The World’s Best Kits.® MetraOnline.com © COPYRIGHT 2020 METRA ELECTRONICS CORPORATION REV. 2/12/20 INSTMPS-GEN01 INSTALL ATION INSTRUCTIONS MPS-GEN01 If you are having difficulties with the installation of this product, contact our Tech Support line either by phone at 386-257-1186, or email at [email protected]. Before doing so, look over the instruction booklet a second time and ensure that the installation was performed exactly as the instruction booklet is stated. Have the vehicle apart and ready to perform troubleshooting steps before contacting Metra/Axxess Tech Support.