Ogawa Ai Masterdrive Installation Manual

Ogawa Assembly Instructions Ogawa AI Master Drive massage chair arrives in 3 boxes. Open box 1 and remove all contents. Remove the packing materials. Take the chair out of the box. Collect all the accessories and put them aside. 1 OG-8800 Calibrated Instument Please Do Not Drop THIS SIDE UP BLUE & SAND BLUE & SAND OG-8800B-5083 Calibrated Instument Please Do Not Drop OG-8800 BLUE & SAND BLUE & SAND (BOX 3 OF 3) (BOX 3 OF 3) FOOTREST FOOTREST Calibrated Instument Please Do Not Drop OG-8800 BLUE & SAND BLUE & SAND

switch. The chair will go back to home position. Then disconnect the power cord. 2 Open box 3 with footrest. Take out footrest and remove the cotter pin and bolt and put aside. 3 Here is where the cotter pin and bolt are located. Here is what it will look like after the cotter pins and bolts have been removed. Here are the cotter pins and bolts. Remove cotter pins and bolts from chair base. Locate the two cotter pins and bolts on the chair base. Take them off and put them aside, then take off the cable ties to release the link rod. 4 Connect footrest to base. Move footrest close to the chair. Engage the link rod with footrest joint. Then insert the bolt and lock with the cotter pin. 5

connected. Here is what it will look like after you detach the side board cover. Here are the two side boards. Connect wires in footrest. Connect both footrest wire connectors and screw the caps tight. Then connect the air hose. Caution: After the wire connector has been connected the cap must be screwed tight. 6 Fully connect footrest to base. Move the footrest closer to the chair. Engage the joints of the footrest and the base. Lift footrest up to align the holes on the joints, then insert the bolt and lock it with cotter pin (that you had set aside). 7 Open box 2 with side boards. Take out the side boards. Detach the cover from the side board. 8 Attach the right side board. Remove the cable tie to release the air hose first. Then fix the five double-threaded screws onto the frame. 9 Here is what the connector looks like. Here is the cable tie you are to cut off. Here is what it will look like once you have fastened in the double-threaded screws. Here is how you detach the side board cover.

through the hole of the side board. Then fix the side board with screw, nut, and washer. 10 Attach the left side board cont. Repeat 9,10,11 to fix the left side board onto the chair. And please Note that the left side board only has the one way air hose. 12 Connect all wires in the right side board. Connect the wire connector and five way air hose to the side board. Then connect the one way air hose. 11 Here is the wire connector. Here is the five way air hose. Here is the one way air hose. Here is what it will look like with all the wires connected. Here is what it will look like with all the wires connected.

screws. 13 Attach the side board covers. There are two pillars on the side board and two pillars on the side board cover. Move the side board cover close to the side board and align the snap joints. Pinch the lower side board to connect. Then knock the edge of the side board cover to make sure all of the snap joints are clamped. 14 Attach the speaker covers. These are also attached by snap joints. Attach the side covers first, then the decoration strip on the top. 15

Secure it with the screw nut. Then attach the pulse sensor and tablet onto the holder. 16 Attach the backrest pad to the backrest. Zip the zipper on top of the backrest. Then fix the elastics of the backrest pad to the backrest. 17

18 Turn on the chair. Connect the chair to a power supply and turn on the power switch. 19