ABB FEPL-02 Ethernet POWERLINK Quick Installation And Start-up Manual

Quick installation and start-up guide FEPL-02 Ethernet POWERLINK adapter module Safety instructions WARNING! Obey the safety instructions. If you ignore them, injury or death, or damage to the equipment can occur. See the user’s manual. Mechanical installation Electrical installation  Layout of the module 1. Pull out the lock. 2. Install the module carefully to an option module slot of the drive. See the drive hardware manual. 3. Push in the lock. 4. Tighten the screw to torque 0.8 N·m using a Torx TX10 screwdriver. WARNING! Do not use excessive force, or leave the screw too loose. Over- tightening can damage the screw or module. A loose screw decreases the EMC performance, and can even cause an operation failure. 1 3 4 �� No. Description 1 Lock 2 Mounting and grounding screw 3 RJ-45 connector [X1] 4 RJ-45 connector [X2] 5 Diagnostic LEDs 6 MAC ID 5 3 2 4 1 6

1. Connect the network cables to connectors [X1] and [X2] on the module. 2. Connect the cable from the master to the left port [X1]. 3. In the line topology, if there are more slave devices in the same line, connect the next slave device to the right port [X2]. Start-up When the module is connected to the drive, the drive control program sets the applicable parameters. See the appropriate drive manual.  Basic parameter settings To take the settings into use, validate and refresh the parameters with parameter 51.27 FBA par refresh. Further information Index Name Value 20.01 Ext1 commands Fieldbus A 22.11 Speed ref1 source FBA A ref 1 28.11 Frequency ref1 source FBA A ref 1 50.01 FBA A enable Enable (or select the option slot in which the module is installed). This activates the communication module. The HOST LED becomes green. 50.02 FBA A comm loss func Fault 51.02 Profile The CANopen device profile (CiA 402) is the default value. See the latest version of FEPL-02 Ethernet POWERLINK adapter module user's manual (3AUA0000123527 [English]) in ABB library (www.abb.com/drives/documents). For more information on fieldbus options and protocols provided by ABB Drives, see the fieldbus communications web page (new.abb.com/drives/connectivity/fieldbus-connectivity). 3AXD50000158164 Rev A (EN) 2017-11-23 FEPL-02 manual Fieldbus communications web page