CAB 4712 Service Manual

Before the applicators are delivered, a transportation lock (4) is mounted on the rod (1). For the labeling operation, the transport lock (4) is pushed onto the stopper (2). The�stopper�(2)�brakes�the�lifting�movement�and�triggers�the�flag�formation. 2 4 3 1 Releasing the transportation lock 1. Loosen the screw (3) of the transport lock (2). 2. Move the transport lock (4) on the rod (1) to the stopper (2). 1. Tighten�the�screw�(3)�of�the�transport�lock�(2)�to�fix� the position. If the position of the stopper ( ...

Exhaust throttle valves are installed on the cylinders of the applicator. The valves control the movement of the cylinders in the direction of the valves. move in direction of the piston move out direction of the piston Fig. 31 Throttle valves on the cylinders i Note!  When replacing or re-adjusting the throttle valves, always adopt the settings from the test report! The setting values are the revolutions of the adjusting screw on the throttle valve. To do this, the throttle valve is completely closed. Turn the adjusting screw on the throttle v ...

cylinder (1) Z 51 Sensor start position cylinder (1) Z 47 SUB-D 9 Interface to the printer 53 Sensor start position cylinder�flag CON 21 CON 22 54 Sensor end position cylinder�flag Fig. 54 Block diagram 57 EEPROM 55 Sensor cylinder pliers CON 31 CON 32 56 Sensor cylinder peel position ...

 Start menu.  Select Setup > Labelling. Parameter Meaning Default Transfer mode Setting the operation mode Blow on Blow on Cycle sequence Setting the application mode Print-Apply : An external start signal releases the print of a label and following the application of the label. After a cycle is complete, the pad without label waits in the start position. Apply-Print: An�extra�signal�starts�the�print�of�the�first�label�and�the�transfer�of�the� label to the pad. T ...