Amico AHM Installation And Adjustment Instructions

1 Monitor Mounting Adapter VESA LCD mount shown, other options available 2 Monitor Head - Rotation Monitor Rotation Adjustment 3 Monitor Locking Lever Locks the arm at a desired height 4 Counter Balance Used to adjust for zero movement 5 Extension Arm * 6” extension arm shown 6 Mounting Adapter MON adapter shown for MRS rail 7 Monitor Head - Tilt Tilt Adjustment Handle 8 Cable Management Manages the cables for better organization Quick Setup Adjustable Height Monitor (AHM) Arm Installation and Adjustment Instructions Installation Tools & Reference Medical Facility Responsibility 2. Installation to Monitor It is the responsibility of the end user to ensure all aspects of the installation are covered by following the full manual at: http://www.amico.com/pdf/accessories/AHM_Manual.pdf 1. Installation to Structure Amico Accessories | www.amico.com 85 Fulton Way, Richmond Hill Ontario, L4B 2N4, Canada 4 x 1/4-20 Set screws Use 1/8” (3mm) hex key to tighten Hex key (1/8”, 3/16”, M3, M4) - 1 Philips screw driver Socket wrench (12mm, 1/2”) - 1 Adjustable wrench ** ** Not provided by Amico * LCD mount shown, for other monitor styles, refer to manual. * Insert screws through M4 holes into back of monitor (4x) * If requested 1. Monitor Mounting Adapter (Pg. 12-18) VESA LCD mount shown, other options available 2. Monitor Head - Rotation (Pg. 22) Monitor Rotation Adjustment 3. Height Locking Lever (Pg. 25) Locks the arm at a desired height 4. Counter Balance (Pg. 27) Used to adjust for zero movement. 5. Extension Arm (Pg. 26) 6’’ extension arm shown 6.Mounting Adapter (Pg. 6-10) MON adapter shown for MRS rail 7. Monitor Head - Tilt (Pg. 21) Tilt Adjustment Handle 8. Cable Management (Pg. 29) Manages the cables of the Monitor for better organization. 2 3 4 5 6 1 7 8 *WARNING: Never attempt to mount or remove the arm from the rail when a monitor is installed. 7 *WARNING: Support AHM arm until the set screws are tightened, AHM arm can slide down when set screws are not tightened. Toll Free Tel: 1.877.264.2697 l Tel: 905.763.7778 Fax: 905.763.8587

A. Rotation (AHM Side to Side) B. Head Tilt C. Rotation (Monitor Head Side to Side) D. Height Locking Lever Adjustments Insert Height Locking Lever E. Counter Balance Amico Accessories | www.amico.com 85 Fulton Way, Richmond Hill Ontario, L4B 2N4, Canada F. Cable Management Quick Adjustment Reference Adjustable Height Monitor (AHM) Arm Rotate Mid Point Rotate End Point To adjust arm height, always be sure to loosen the height locking lever first. Loosing or tightening this bolt will adjust the resistance of the arm. When properly counterbalanced, arm should remain in neutral position when unlocked. Counter Balance Bolt (1/2”) Opening to the cover Height Locking Lever Cable Guide Bottom of the AHM Arm Cable Cover Cable Guide Counter Balance Bolt (1/2”) Height Locking Lever: Rotate Counter-Clockwise to Release Rotate Clockwise to Lock To rotate at first arm To rotate at second arm Hex * * If applicable Toll Free Tel: 1.877.264.2697 l Tel: 905.763.7778 Fax: 905.763.8587 Cable Guide Bottom Side of the AHM Arm Grooves Insert cables into cable guide, then squeeze cable guide and press onto the bottom of the AHM. Bottom Side of Cable Cover