Avid Technology AirSpeed 5000 Verification And Test Procedure
Text of the manual
AirSpeed 5000 Verification and Test
Procedure
Table of Contents
Scope ......................................................................................................................................................... 1
Requirements .......................................................................................................................
remove and replace the Field Replaceable Units (FRUs) in the AirSpeed 5000 system, and then re-test to
confirm correct operation.
The test process may also be followed by customers or service personnel to diagnose an AirSpeed 5000
system if an issue is suspected, or to confirm the hardware is operating correctly if the system if the has
been moved, shipped
[RAID: (Bus 09 Dev 0]
6. Using the arrow keys, move to the exit menu. Select “Save Changes and Exit”. The system will now
boot into windows.
Media Drive Verification
This section covers the procedure used to verify the Media Disks are installed correctly.
1. Verify that the blue LED’s are lit on all 10
Avid Health Monitor
1. The status of the systems temperatures, voltages, motherboard, system fans, hard disk and Avid
hardware can be viewed in the Health Monitor.
2. To open the Avid Health Monitor to view the health of the AirSpeed 5000 system.
1.
Select Start > All Programs > Avid > Avid Framework > Avid Health Monitor.
2.
From the Select Workgroup wind
Yellow exclamation point: Warning status.
•
Red X: Failing (errors) status.
Customer Diagnostics Test Setup
Installing loopback Cables
1. The VIO (Corona) cards are the top 2 cards in the system (VIO1 (Corona 1) and VIO2 (Corona 2)). As
shown in the picture below.
2. Install loopback cables on the VIO cards, which the diagnostics use to send and re
