CAB 4712 Assembly Instructions Manual

3 1 2 • Applicator with mounted tamp assembly (1) • Adjustment tool for the tamps (2) • Blow tube for supporting air (3) (depend of the used printer) • Air pressure regulation unit (4) • Documentation and test protocol 4 Fig. 4 Content of Delivery i Note! Please keep the original packaging in case the applicator must be returned. ! Attention! The device and printing materials will be damaged by moisture and wetness. X Only set up the label printer with applicator in dry locations protected from moisture and splashes. 2 Product Description ...

X Start menu. X Select Setup > Labelling. Parameter Meaning Default Transfer mode Setting the operation mode Blow on Blow on Cycle sequence Setting the application mode Print-Apply : An external start signal releases the print of a label and following the application of the label. After a cycle is complete, the pad without label waits in the start position. Apply-Print: An extra signal starts the print of the first label and the transfer of the label to the pad. The external start signal releases the application of the ...

Via the negative pressure the label is fixed to the applicator. This vacuum needs to be strong enough to hold the label and cover all suction apertures. It may not be strong enough to hinder the transport of the from the printer to the applicator. This is dependent on the label material used. The default value of the vacuum is -0.6 bar. i Note! By adjusting the vacuum it is possible to prevent the label from being applied to the product. If the vacuum is too strong the label will not be released by the pad. If the vacuum is set too high the advanceme ...

y x z y x z 1 2 3 4 5 6 7 Fig. 16 Displacement in the Y direction Displacement in the X direction (Side) 1. Loosen screw (3) on the binder (5). 2. Move cylinder assembly with the pad along the crossbeam (4) so that the dispensed label (7) is aligned centrally to the pad (6). As reference use the provided graduation/ruler on the crossbeam. Orientation: Graduation (2) and Marking (1) 3. Tighten screw (3). text side 1 text side 2 L L D (Ø) x Pi ( ) D L V P Fig. 17 Label parameter A misalignment of the stamp to the printer can be recog ...