Cleanfix Pelican QuadVac + Safety, Operation & Maintenance Manual

11 TROUBLESHOOTING (cont.) Symptom: Weak vacuum! Problem: Worn out lid gasket. Solution: Replace lid gasket (# 12062). Problem: Defective vacuum motor (noisy bearing, carbon brush sparking burn out armature & worn out carbon brush). Solution: Replace vacuum motor (# 12210) and motor gasket (# 12062.1). Problem: Lint accumulation on vacuum filter screen. Solution: Clean filter screen. If screen is defective, replace screen (# 12076.1). Symptom: Weak/no spray from spray tips! Problem: Clogged spray tips/check ...

6 FUNCTIONAL PARTS AND ACCESSORIES (cont.) PELICAN QUADVAC AUTO Front View (1) Recovery tank with clear high impact resistant dome – Dome must be closed when using the machine. (2) Solution tank. (3) Solution pump switch (lighted when it is on). (4) Two (2) “Vacuum” switches for primary vacuum motors (lighted when it is on). (5) 2” vacuum hose adaptor. (6) Drain valve for recovery tank – Pull “T” handle up to open. Drain valve must be closed after each use. Install drain elbow upon receipt of ...

5 FUNCTIONAL PARTS AND ACCESSORIES (cont.) PELICAN QUADVAC Rear view (10) Power cord for primary vacuum motors. (11) Cooling fan for motor compartment. Maintain clearance between a wall and the machine. Do not block fan outlet. (12) Circuit Locator - Green light comes on when cord for the secondary vacuum motors is plugged into a second circuit, independent from the circuit where the first cord is plugged in. (13) Power cord for secondary vacuum motors. (10) (11) (13) (12) ...

3 GENERAL PRECAUTIONS (cont.) • If an extension cord is necessary, use a 12 ga. or heavier grounding cord to prevent motor burnout and overheating of wires. • Do not expose machine and wand to freezing temperatures or store in areas where the solution lines can freeze. The solution pump head and valve on the wand will crack if liquid is present on the solution line. Empty out the solution line if machine is to be stores for a long period. GROUNDING INSTRUCTIONS - 120 VOLT Improper use of the grounding pl ...