DynaLock 1661 Series Installation Instructions

minimum of 3⁄16" clearance. 2. Determine the horizontal center line ‘G’ of the Pullman Latch of the exit device, and transfer to frame stop. (see fig. 1) 3. Determine the vertical center line of the Electric Strike ‘X’ by adding 3⁄4" to dimension "R" (See Fig.1) and measure from the push side of the door to frame stop for ‘X’. 4. Prepare door jamb as per template drawing for full surface mounting. (see preparation "V") 5. Ensure that strike insert is placed in the center most position on the faceplate prior to installation. This allows for maximum adjustability when installation is complete (see Fig. 2). 6. Connect wires from power source to terminal screws on strike (polarity is not observed). 7. Using slotted holes in chassis, install exit device electric strike with 2 SHCS 1⁄4 - 20 x 1”, socket head cap screws provided. 8. Adjust chassis and electric insert (if necessary), horizontally, until Pullman Latch engages when door is closed. Finally tighten screws. Important: Be sure exit device dead locks when door is closed before proceeding to step 9. 9. Mark, drill and tap for the locking screws provided, and install to secure final location with 2 SHCS 1⁄4 - 20 x 1”, screws provided. Note: If further adjustment is needed later, to correct door or weatherstrip misalignments, horizontally move insert on its furrows by loosening screws under the face plate, and re-tighten when in the corrected position (Fig. 2.). Important: The 1661 Electric Strike is never to be used as a door stop. Please install stops on frame in appropriate locations. Ensure the exit device functions as intended for life safety concerns by verifying electric strike and exit device compatibility. Maximum latch projection is essential to obtain full holding force. ©2005 DYNALOCK WWW.DYNALOCK.COM 705 EMMETT ST. P.O.BOX 2728 BRISTOL, CT 06011-2728 USA PHONE: 860-582-4761 FAX: 860-585-0338 EMAIL [email protected] 1661 SERIES COMMERCIAL ELECTRIC STRIKE CENTERLINE LATCH ENTRY FOR RIM EXIT DEVICE

Template For 1661 Series Strikes MODEL # 010203 Preparation for mortising electric insert for model 010203 Vertical center line of 010203 MEASUREMENT FRACTIONAL INCHES DECIMAL INCHES METRIC mm X G V S M M O P C Q K K PREPARATION Insert Semi-mortise Mounting Preparation “V” Future alignment problems can be corrected by loosening the two insert screws and moving the insert horizontally across the furrows. Original preparation is not disturbed. (Fig.2). IMPORTANT If Exit Device Strike (supplied with device) is of 1⁄2" or 5⁄8" projection, please use" Insert Semi-mortise Mounting" or Preparation "V". Exit Device Door Edge R G cL Note: DO NOT SCALE SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. Fig.1 C 1 5/8 1.625 41.3 G K 4 1/8 4.125 105 M O 5/16" .312 8 P 21/2 2.5 63 Q 1 3/8 1.375 35 V X Horizontal center line of Pullman Latch 1/4 - 20 Tap ©2005 DYNALOCK WWW.DYNALOCK.COM 705 EMMETT ST. P.O.BOX 2728 BRISTOL, CT 06011-2728 USA PHONE: 860-582-4761 FAX: 860-585-0338 EMAIL [email protected]